Hi guys, Whilst looking at the TYP(elmt) command in the on-line help I found the VIS(elmt) command right under it! Thanks anyway.
My next question is about the TYP(elmt) command. I note that Surface is not shown although from trial and error I've found that if the element is a surface it is TYP 50. I remember a while back someone kindly posted all the commands 'hidden' and not listed anywhere, could someone kindly post the list again and I'll try not to lose it this time! Regards, Bill in the UK. P.S. I live in Bristol where Concorde was built, (CNC programmed some parts for it when I was younger). Took this morning off to drive onto some high ground to see the LAST flight by a Concorde anywhere, coming home for the last time, watched it land in the distance. Sniff. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
