|
I use “st_notes” in my tool report format file.
Attached are the .fmt files that I use to produce our tool list and setup instructions for our Bostomatic operators.
The Report.txt file is generated through a macro and is over written each time the macro is executed with each new program.
All the files are kept in C:\SM11\MILL\JOSRPT directory. I tried using other directories on our network data sharing drive to store the .fmt files but all I got was grief. Not sure why, but for some reason the .fmt files seem to only work in the C:\SM11\MILL\JOSRPT directory.
Regards, Michael Senack
-----Original Message-----
Hello again SmartCAMmer's,
Does anyone know what I need to put in the .fmt file to output the tool notes from the planner? Anyone, Anyone, Bueller
Would it be tl_notes?
Jeff Pieper EATON Fluid Power |
TOOLLIST.fmt
Description: TOOLLIST.fmt
msteprpt.fmt
Description: msteprpt.fmt
Job Setup File = w:\bo1000\BO0376.jsf
Date Created = 12/02/03
Created by = Michael Senack
Machine Type= Mill Units= Inch
Part Description = 33" DIE PLATE
Material Description = D2 - 32.94L X 8.0W X 1-1/2TNotes = BLOUNT CANADA LIMITED #S4=BDA-2126S-3 REV.AB OP.1 33" DIE PLATE D2 - 32.94L X 8.0W X 1-1/2T -PICKUP BACK L.H. CORNER OF PART AND SET T0 X2.5 Y0.0 -SET Z HEIGHT TO 4.0 INCHES -USE 1.0 OF 1-2-3 BLOCKS BY 6 PLACES UNDER DIE PLATE -REFER TO SETUP SHEET FOR PLACEMENT OF CLAMPS, STOPS AND 1-2-3 BLOCKS T6 = NO.15 C/DRILL 7/16 X 5/32 H Speed Code: 54 RPM Feed: 1.00 IPM T30 = 17/32 DRILL(.531) L Speed Code: 60 RPM Feed: 1.50 IPM T39 = 1.0 DRILL L Speed Code: 33 RPM Feed: 0.60 IPM T26 = 1.0 ROUGH E/M L Speed Code: 45 RPM Feed: 1.00 IPM T19 = 45/64 DRILL(.703) L Speed Code: 44 RPM Feed: 1.00 IPM T20 = 23/32 DRILL(.718) L Speed Code: 44 RPM Feed: 1.50 IPM T13 = 21/64 DRILL(.328) L Speed Code: 89 RPM Feed: 1.60 IPM T14 = 11/32 DRILL(.343) L Speed Code: 89 RPM Feed: 1.60 IPM T9 = LETTER U DRILL(.368) L Speed Code: 89 RPM Feed: 1.60 IPM
JOBINFO.fmt
Description: JOBINFO.fmt
