Dennis, You're going to want a wire thread (T91) in the @START section after the #MOV line and in the @RAP section.
You'll also need the wire cut (T90) in the @RAP section and also in the @END section if you want the wire cut at the end of the job. The following line is needed in the @STPROF section: #IF(#XPOS<>#XST,#OR#YPOS<>#YST)<#CALL(RAP)> A stripped down version of my @RAP section looks like this: @RAP T90 M03 // if your machine has this feature, it's a must use. #MOV X#XPOS Y#YPOS T91 I could send you my tmp file but I really need to clean it up (looks worse than the garage) and strip it down first. What machine and control do you have? Pete -----Original Message----- From: CNC [mailto:[EMAIL PROTECTED] Sent: Tuesday, January 06, 2004 11:32 AM To: SmartCam users group (E-mail) Subject: [mfg-smartcam] Sodick post Hi all, Does anyone have a post for a sodick wire that they would be willing share. Or some advice on cutting and stringing the wire( for coding), how is it put in, User Events? I usually program mills, but I am starting the wires now, too. Thanks much! Dennis Handzel IMS/EXTON. 128 N. Lively Blvd. Elk Grove Village Ill. 60007 E-mail : <[EMAIL PROTECTED]> ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
