RE: [mfg-smartcam] Spindle on/off

[Chris . Kocourek]

Bob,

 

My method of programming probes was to insert a user elmt where I wanted a particular probing routine to occur. In my .tmp file I had different sections for each particular routine. Each section positioned the probe and then hard-coded a Fanuc macro call-out. In my case, I created a separate .tmp with all the M3 and M8 codes left out for probing purposes.

 

Example:

 

@USER1
#IF(#U9=1)<***** USER ELEMENT 1ST ARC SECTION  *****>
 G90 #MOV X#XPOS Y#YPOS
 G65 P9023 A1 D2.0 S1

 

@USER2
#IF(#U9=1)<***** USER ELEMENT 2ND ARC SECTION  *****>
 G90 #MOV X#XPOS Y#YPOS
 G65 P9023 A1 D2.0 S2

 

 

Hope this helps.

Regards,

Chris K.

-----Original Message-----
From: Bob Manganello [mailto:[EMAIL PROTECTED]
Sent: Wednesday, April 07, 2004 5:25 AM
To: SCQUEST (E-mail)
Subject: [mfg-smartcam] Spindle on/off

Is there a way to create a tool in the job oper. planner so that the #SPNDL in the .TMP will put out an M5 or nothing? Or do I have to build the logic into the .TMP

 

I need to keep the spindl from starting when I'm probing.

 

Thanks

Bob M.