Well,

I went down and looked at it this afternoon.

1. Sometime during the night the coolant worked back into the radiator. 
The overflow was empty and the radiator took about 3 cups of water to 
top off. In all it means I lost about a quart of water.

2. Swapped out the t-stat with a known good (but used and tested in 
boiling water) t-stat and cranked the car...

3. Lots of oil smoke, still running very rough, maybe on 3 whole 
cylinders now.

4. The coolant was rusty. Like muddy red rusty. Like there was more iron 
than water in it rusty. So rusty that I could barely make out any 
coolant-green in it at all. I swapped radiators about 6 months ago and 
remember a slight rusty color, but not this bad.

5. The coolant also seemed very frothy. Still didn't show oil like I 
would expect (black blobs floating around), but there was something on 
the surface that significantly increased surface tension and the bubbles 
would not pop.

Another point of note - I replaced the alternator and alt/ps belts about 
2 months ago. I remember having a hell of a time getting the alternator 
belt on - it was about 1mm too short at full stretch. Could I 
potentially have damaged the water pump in this process?

Unfortunately I currently only have a gravel drive to work in so I'll 
not be undertaking diagnosis myself. Fortunately my garage is at the 
bottom of the hill, I should be able to idle it to the bottom without 
issue in the AM.

Thanks for the quick respnoses Larry and Bill. It's nice to know some 
long time "friends" from the list are always willing to help out! 
Ironically I was going to be giving FM a call tomorrow morning for some 
unrelated salvage parts. I think I'll hold of on fixing the window 
regulator for a while - nothing a stick jammed under the window can't 
fix while it sits in the shop.

May I solicit one more piece of advice? I realize that you guys aren't 
looking at it directly but considering the age, history and the LWSC - 
at what "price to fix" do I reach the threshold of going to the 
replacement motor mentioned (actually $425 long block '93 @ 140K)? Do I 
even have the shop diagnose and pay the labor of pulling the head? Or 
would I be better off resigning myself to the worst and save that money 
for a full front end rebuild on the new motor (timing, water pump, 
pulleys, et al) on the replacement motor?

Thanks again!

Brad

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to