Why not just pull the compressor outlet pipe and see if you have anything
more than trace oil? If you do have a little oil, make sure it's not coming
from the cam vent line (pre-turbo), *if you have one*.

-Ed

-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Ashraf Farrag
Sent: Thursday, July 31, 2008 11:29 PM
To: Lloyd Broussard
Cc: Miatapower
Subject: Re: Checking turbo seals for leaks

Lloyd Broussard wrote:
> Is there a easy way to check out the condition of the turbo oil seals 
> while the turbo is mounted to the manifold and is in the car?
>   
I'm totally shooting from the hip and attempting to improvise based off a
similar experiment I just performed but could you block off the drain and
pressurize the feed with air, say 40-50 psi and listen for it escaping
(provided you have good seals in and out and at all the couplings, where
else can it go?  Unless there is some reason that you need oil specifically
as the compressible "fluid" because somehow it helps to seal?  I don't
imagine the CHRA has to be spinning to seal.  I do know that journal
bearings like to have oil for everything to "seat" 
correctly and not have play.  I guess the question is if that thin film of
oil in the bearings have anything to do with the whole shebang sealing.  My
gut reaction is no and that it should still seal if the seals aren't blown.
Ceramic/ball-bearing I imagine should seal no questions since there is no
"loose fit" journal bearing.

Tried calling Garrett, Turbnetics or a turbo rebuilder to see if they have
insights?

Regards,
--Ashraf
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to