Put a noid light on the injector to verify signal. If no signal, verify
the wiring done when you converted to sequential. Maybe a pin has pulled
out at the ecu.
 

Bill Cardell 
TurboDog's Dad 
www.flyinmiata.com 
www.fmwestfield.com 
Sales 1-800-359-6957 
Tech 970-464-5600 Before you call, check out
http://www.flyinmiata.com/FAQ/ 
Come to our Open House! August 14-17 

 

________________________________

From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of
[EMAIL PROTECTED]
Sent: Friday, August 08, 2008 1:18 PM
To: [email protected]
Subject: #4 cylinder not firing


1991 miata link ecu, 1.8 engine swap. turbocharged, car had ran fine for
about 3 months then started having some symptoms of a random misfire. it
seemed that the plug wire was not making good contact on the coil pack.
recently it has become a continuous symptom. I have checked for spark by
attaching a sparkplug to the #4 plug wire and observing the arc will the
motor was running.  I confirmed no combustion in cyl # 4 by placing my
hands on the manifold at # 1 & #4 simultaneously from a cold start and
observed the lack of heat at # 4. i replaced the generic injector
connector at #4 fuel injector to eliminate possible poor connection
there.. I swapped the # 1 & #4 fuel injectors to eliminate bad fuel
injector. Future action planned is to try and remove the fuel rail again
and crank the car and observe for fuel spray. (trying to make sure fuel
inj. is getting signal to fire} any other help is very much appreciated.
I have checked compression to eliminate worse case scenario and it is
165 across the board.

TIA
Michael 
________________________________

It's time to go back to school! Get the latest trends and gadgets that
make the grade on AOL Shopping
<http://shopping.aol.com/back-to-school?ncid=aolins00050000000007> . 
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to