Thanks Ray, I wondered how that was exactly.. I like it, but not sure the old model markI could still do it with the wideband and temp comp mod's installed or not. No sequential.
Regards CB ----- Original Message ----- From: "Ray Ayala" <[email protected]> To: "MiataPower Power Miata" <[email protected]>; "Rob Ebersol" <[email protected]> Sent: Wednesday, February 25, 2009 9:53 PM Subject: Re: EBC settings Qs > During spoolup assist the Link opens the solenoid all the way to bleed off > all the pressure signal so that none of it reaches the actuator. This > condition will continue until boost reaches the target. Then (if adjusted > correctly) it gradually decreases the % of bleed-off as rpm rises toward > WGrpm. At WGrpm the % of bleed-off is whatever was determined during the > 1st step of boost control setup. > > > ----- Original Message ----- > From: "Rob Ebersol" <[email protected]> > To: "MiataPower Power Miata" <[email protected]> > Sent: Wednesday, February 25, 2009 12:37 PM > Subject: Link: EBC settings Qs > > >> "Boost Assist" - Is this the process of the LINK close the solenoid >> to prevent any signal getting to the WG acuator? Is it initiated by >> WGbase? and ended by WGrpm? >> >> IF SO- >> Any negative effects from starting "boost assist" shortly after boost >> onset to control a ultra sensitive actuator from initiating movement >> on the valve. Specifically to address my actuator that starts >> movement at 4psi and completes it at 14psi. Just planning my next EBC >> tuning outing. >> >> thx-rob >> _______________________________________________ >> Miatapower mailing list >> [email protected] >> http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower > > _______________________________________________ > Miatapower mailing list > [email protected] > http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
