Ian McCloghrie wrote:
> Maybe it's fuel-injected and it needs the battery to get the ECU 
> running? :)
This is way, way off topic at this point but here are my musings on that 
subject...  ;-)

When I was fighting the carburetor, I was "this close" (well, not 
really, since it is not practical) in frustration (and to some extent 
still am, since it doesn't run well under power) to just making a big 
experiment out of it and converting to a jury rigged DIY fuel injection, 
probably the microsquirt variant of the Megasquirt project.

I've seen that the bits and pieces to do just that are starting to be 
developed but I don't think they have hit the market quite yet.  They 
(Bosch) apparently have started to develop small engine fuel pumps (more 
a problem, IMHO than the computer).  Could probably even use a 
carburetor pump at low pressure...I think I read that some small engine 
actually have a pump.

Injectors for that size of displacement probably aren't common, though, 
so I'm not sure what off-the-shelf component you could borrow/use.  
Given the fuel atomization isn't a huge issue, I wonder if some sort of 
industrial standard solenoid valve could be used in front of a carb jet 
to meter the fuel for the engine size (same ones that folks use for 
boost control solenoids).

The ECU, for constant load, wouldn't take much computer to inject the 
fuel if you keep the magneto for ignition, in fact, the rotary airplane 
guys came up with an "ECU" that used a 555 timer chip.  Genius of a 
hack.  Pure genius, I tell you. 

I wonder if there's enough output from a larger magneto that could 
charge a capacitor to run the ECU/pump/injector to bypass the battery.  
Pull #1 charges the capacitor.  Pull #2 starts the mower.

For a unit cost of $350, I don't think they can replace the carburetor 
with fuel injection and keep the costs reasonable on a push-mower 
(yet).  I think it makes sense for inject a riding mower/tractor for the 
immediate future.

I also saw somewhere that there will be new emissions requirements for 
small engines?  That may be the real push to engineer fuel injection for 
that market segment.

Alternately, I could just yank the carb (again), dip it in the parts 
dip, reset the float and it will probably work right. 

Take note, Bryan:
I just need to remember to drain the gas at the end of each season or 
put Stabil in there so it doesn't varnish the carburetor innards.  :)

Regards,
--Ashraf
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to