Ok, I have set up tons of these in 2.9.x. This is my first in 3.x stable. Version right now is 3.7. I have done one in 3.0RC9. I am setting up an ap in ap-bridge mode, added the bridge then added ether1 and wlan1 "ports" to the bridge. There are no clients on this yet. Looking in winbox it shows in bridge port, ether1 as designated port and wlan1 as disabled port. It is not grayed out and I have disabled and enabled it in the bridge port wlan1. In 2.9 when I did this it would show both as forwarding. In RC9 it showed both as designated port. I have done the same config in 3.7 and I get the above. So can someone tell me what the deal is? It doesn't appear I can do anything with either of those ports. The radio is a R52H and is enabled.
Thanks, Terri Kelley Network Engineer 254-697-6710 This email message is intended only for the named recipient(s) above, and may contain, together with any attachment(s), confidential information that is privileged. If you are not the intended recipient, be advised that you have received this email in error and that any use, dissemination, forwarding, printing, copying or distribution of this message and any attachment(s) is strictly prohibited. -------------- next part -------------- An HTML attachment was scrubbed... URL: http://www.butchevans.com/pipermail/mikrotik/attachments/20080612/71e12c2e/attachment.html -------------- next part -------------- A non-text attachment was scrubbed... Name: LogoHzlsigtest.jpg Type: image/jpeg Size: 2158 bytes Desc: not available Url : http://www.butchevans.com/pipermail/mikrotik/attachments/20080612/71e12c2e/attachment.jpg
