Is DHCP setup required since I'll be using the router upstream for NAT
instead of the MT router?
-Eric
On 2/15/2010 4:40 PM, Josh Luthman wrote:
On the "MT Hotspot Router"
Put an IP for WAN
Put an IP for LAN
Run DHCP setup on LAN
Run Hotspot setup on LAN
Then set the Wifi AP to a LAN IP and for your sanity give it an ip-binding.
Plug Wifi AP into LAN
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
“Success is not final, failure is not fatal: it is the courage to continue
that counts.”
--- Winston Churchill
On Mon, Feb 15, 2010 at 5:33 PM, Eric Muehleisen<[email protected]> wrote:
Can anyone point me to a config where I can place a MT router in the middle
of a Router doing NAT and the customer? I'd like to place a captive portal
right in the middle without disturbing the existing LAN network.
Internet --> Router w/NAT --> MT Hotspot Router -->WiFi AP --> Customer PC
Can't seem to find what I'm looking for from the MT forum.
-Eric
_______________________________________________
Mikrotik mailing list
[email protected]
http://www.butchevans.com/mailman/listinfo/mikrotik
Visit http://blog.butchevans.com/ for tutorials related to Mikrotik
RouterOS
-------------- next part --------------
An HTML attachment was scrubbed...
URL:<http://www.butchevans.com/pipermail/mikrotik/attachments/20100215/a2dc7163/attachment.html>
_______________________________________________
Mikrotik mailing list
[email protected]
http://www.butchevans.com/mailman/listinfo/mikrotik
Visit http://blog.butchevans.com/ for tutorials related to Mikrotik RouterOS
_______________________________________________
Mikrotik mailing list
[email protected]
http://www.butchevans.com/mailman/listinfo/mikrotik
Visit http://blog.butchevans.com/ for tutorials related to Mikrotik RouterOS
