Thank you, that is it! Now it is clear, the layer 2 must be present to send neighbour solicitations for dad. But I think the older kernel 2.6.11 is a little bit different in that point.
But know eyerthing works. I also have switched off autonegotiation and use 10baseT Half Duplex because I only have hubs. Maybe that was also a problem. regards sebastian Am Montag, 10. April 2006 09:46 schrieben Sie: > Jean-Mickael Guerin wrote: > > [EMAIL PROTECTED] wrote: > >> Hallo, > >> > >> I have still the reported problems with the IPv6-Addresses which are > >> always in tentative mode. > > > > IIRC they are kept tentative as long as the device is not up & running, > > so have a look to device status or try with another network card. > > I'm not sure the pb you have is MIPL2 specific. > > In 2.6.15, the link must be up for the device to be in the up & running > state. This means an the cable must be plugged in at both ends if you > are using an ethernet NIC. > > HTH, > Ville _______________________________________________ mipl mailing list [email protected] http://www.mobile-ipv6.org/cgi-bin/mailman/listinfo/mipl
