Regards.
I tried to upgrade my 3.6 OpenBSD to 3.7.
I tried to upgrade from CD, but the kernel faulted.
dmesg results:
....
umass0: DATAFB Flash Reader, rev 2.00/11.25, addr 2
umass0: using SCSI over Bulk-Only
scsibus1 at umass0: 2 targets
sd0 at scsibus targ 1 lun 0: <Generic, STORAGE DEVICE, 1125> SCSI0 0/direct removable
sd0: drive offline
sd1 at scsibus targ 1 lun 1. <Generic, STORAGE DEVICE, 1125> SCSI0 0/direct removable
sd1: drive offline
sd2 at scsibus targ 1 lun 2: <Generic, STORAGE DEVICE, 1125> SCSI0 0/direct removable
sd2: drive offline
sd3 at scsibus targ 1 lun 3: <Generic, STORAGE DEVICE, 1125> SCSI0 0/direct removable
sd3: drive offline
dkcsum: wd0 matched BIOS disk 80
kernel: integer divide fault trap, code=0
Stopped at ststrategy+0x44 divl 0x28(%edi),%eax
ddb>
I have IDE HDD. wd0. OpenBSD 3.6 on boot dmesg says:
umass0: DATAFB Flash Reader, rev 2.00/11.25, addr 2
umass0: using SCSI over Bulk-Only
scsibus1 at umass0: 2 targets
sd0 at scsibus targ 1 lun 0: <Generic, STORAGE DEVICE, 1125> SCSI0 0/direct removable
Automatic boot in progress...
And everyting goes well with 3.6. Only 3.7 faults.
Any suggestions?
-- Adam Papai
