Heya On Wed, Jun 22, 2011 at 12:13 PM, Paul Suh <pl...@goodeast.com> wrote:
> Folks, > > Is this possible and/or a good idea? I have a router with three interfaces: > > sis0: external interface, IPv4 address 1.2.3.4/24 > sis1: internal interface, IPv4 address 192.168.1.1/24 > sis2 <http://192.168.1.1/24sis2>: DMZ interface, IPv4 address > 192.168.2.1/24 > > NAT rules pass all traffic from the internal and DMZ zones through the > external IP address. I have a couple of servers with IPv4 addresses > 192.168.2.2 and 192.168.2.3 in the DMZ, with rdr-to rules that send traffic > in > to them from 1.2.3.4. > > I need to place a server at 1.2.3.5, and the software I have to run needs > the > server itself to have the IPv4 address 1.2.3.5 -- I can't NAT it and give > the > server the address 192.168.2.4 in the DMZ. (Don't ask. *shudder*) Can I set > up > a bridge between sis0 and sis2 so that traffic for 1.2.3.5 gets passed > through > to the server via sis2 as well as having the IPv4 address 1.2.3.4 on sis0? > Or > is there a better way to do this? > > > --Paul > > [demime 1.01d removed an attachment of type application/pkcs7-signature > which had a name of smime.p7s] > > I personally would check to see if you could get a /30 routed to 1.2.3.4. 5.6.7.8 - 5.6.7.11 Append one of the /30 to the sis2 interface, and the other to your new server. If 1.2.3.4 & 1.2.3.5 are part of a bigger block that you own, see if you can't allocate a /30 from that larger pool. ( 1.2.3.8 - 1.2.3.11 ?? ) Shane