Hi,
pppoe0 has 92.203.101.134.
this works fine:
match out log on egress inet from 192.168.23.0/24 nat-to pppoe0
tcpdump while pinging:
92.203.101.134 > 74.125.39.147: icmp: echo request
74.125.39.147 > 92.203.101.134: icmp: echo reply
92.203.101.134 > 74.125.39.147: icmp: echo request
74.125.39.147 > 92.203.101.134: icmp: echo reply
But this doesn't:
match out log on egress inet from 192.168.23.0/24 nat-to (pppoe0)
tcpdump while pinging:
92.203.101.135 > 74.125.39.147: icmp: echo request
92.203.101.135 > 74.125.39.147: icmp: echo request
in the (pppoe0) mode the IP address is always incremented by one. This
also happens to other ips, not just 92.203.101.134.
pppoe0: flags=8851<UP,POINTOPOINT,RUNNING,SIMPLEX,MULTICAST> mtu 1492
priority: 0
dev: ep1 state: session
sid: 0x166f PADI retries: 1 PADR retries: 0 time: 00:11:21
sppp: phase network authproto pap
groups: pppoe egress
status: active
inet6 fe80::211:25ff:feae:e0c%pppoe0 -> prefixlen 64 scopeid 0x6
inet 92.203.101.134 --> 213.148.133.4 netmask 0xffffffff
