We do not yet have IPv6 rdomain support. I am working on it, but it is not yet production ready. After 5.2, for sure.
On 2012 Jul 17 (Tue) at 11:20:08 +0200 (+0200), Krzysztof Kułaj wrote: :Hi, : :I'm trying to make an simple MPLS network. I desided to use OpenBSD, and I :sucessful implemented mpls ipv4 network by using great document :http://2011.eurobsdcon.org/papers/jeker/MPLS.pdf.(I will use nomenclature :from this document in this post) My network looks similar like network on :page 6 of this document: I have network connected to PE1, one P1 server :inside and PE2 server connected to other customers network. This :implementation is working well, I see MPLS labeled packets on P1, ospf and :bgd make their job. : :Now I want to connect two IPv6 networks throught a MPLS network. The :scenerio looks almost the same like hereinbefore, but "customer" networks :uses only IPv6. I was trying to set up ipv6 addresses on PE1 and PE2 ouside :interfaces, but when I try to do this on mpe0 I have error 'invalid :address'. : :I make IPv6 in IPv4 encapsulation and it works, but I want to have it :without this. : :Network stack with ipv6 in ipv4 encaps on P1 looks: :FRAME :Ethernet :MPLS :MPLS :IPv4 :IPv6 :TCP : :I don't want to see ipv4 here. : :Any ideas how it could be done? The internal ip addresses in inside mpls :network are not visible, so I think there no need to touch them. : :I have one more question, how can I set routing for "customers" network to :get all packets get throught MPLS network? I have seen, that BGP in rdomain :1 set second "customer" network address route to internal address of lo1, :but when I try to add additional addresses manualy I get an error that host :in unreachable. : :Best Regards, : :Krzysztof Kulaj : -- OK, so you're a Ph.D. Just don't touch anything.
