Why were they given to you? Something wrong with them perhaps. Try
booting Memtest86+ ISO and let it ride for a while?
Try another kernel from another OS? Try a non MP kernel?
~BAS
On Wed, 2005-11-16 at 22:01, Lokkju wrote:
> Hey all, hoping someone might be able to point me in some sort of direction...
>
> I recently was given two BOXX brand 1u servers, both of which are the
> exact same - Tyan Thunder LE 2510 dual proc motherboards, with two
> 867Mhz chips per board, and 4 256MB ram sticks per board. The rest
> you can get from the dmesg.
>
> Anyway, I have been trying to get OpenBSD to run on them, and I
> continuously have problems on processor 1 - and no, it does not matter
> WHICH processor is in slot 1. I usually get an apm error, but
> sometimes I get tcp related, or copyout related, or other errors - all
> ending up with me dumped into ddb. These are usually "stopped"
> errors, not panics. In this case, the error is a apm_cpu_idle stopped
> error.
>
> So, here it goes - the dmesg, the trace on each processor, and the ps
> - as I side note, I can almost always instigate this crash by trying
> to untar something big - especially is I use verbose mode.
>
> PANIC
> ********
> # Stopped at apm_cpu_idle+0x4a: leal 0xfffffff4(%ebp),%esp
> ddb{0}> show panic
> the kernel did not panic
>
> DMESG
> *********
> OpenBSD 3.8 (GENERIC.MP) #298: Sat Sep 10 15:51:54 MDT 2005
> [EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC.MP
> cpu0: Intel Pentium III ("GenuineIntel" 686-class) 864 MHz
> cpu0:
> FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,S
> ER,MMX,FXSR,SSE
> real mem = 1073324032 (1048168K)
> avail mem = 972730368 (949932K)
> using 4278 buffers containing 53768192 bytes (52508K) of memory
> mainbus0 (root)
> bios0 at mainbus0: AT/286+(00) BIOS, date 10/31/00, BIOS32 rev. 0 @ 0xfdba0
> apm0 at bios0: Power Management spec V1.2
> apm0: AC on, battery charge unknown, estimated 0:00 hours
> apm0: APM get event: interface not connected (3)
> apm0: APM get event: interface not connected (3)
> apm0: disconnected
> apm0: flags 30102 dobusy 0 doidle 0
> pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
> pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xf5200/192 (10 entries)
> pcibios0: PCI Interrupt Router at 000:15:0 ("ServerWorks ROSB4 SouthBridge"
> rev
> 0x00)
> pcibios0: PCI bus #0 is the last bus
> bios0: ROM list: 0xc0000/0x8000 0xc8000/0x1000
> ainbus0: Intel MP Specification (Version 1.4) (AMI CNB30LE )
> cpu0 at mainbus0: apid 0 (boot processor)
> cpu0: apic clock running at 132 MHz
> cpu1 at mainbus0: apid 1 (application processor)
> cpu1: Intel Pentium III ("GenuineIntel" 686-class) 864 MHz
> cpu1:
> FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,S
> ER,MMX,FXSR,SSE
> mainbus0: bus 0 is type PCI
> mainbus0: bus 1 is type PCI
> mainbus0: bus 2 is type ISA
> ioapic0 at mainbus0: apid 4 pa 0xfec00000, version 11, 16 pins
> ioapic1 at mainbus0: apid 5 pa 0xfec01000, version 11, 16 pins
> pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
> pchb0 at pci0 dev 0 function 0 "ServerWorks CNB20LE Host" rev 0x06
> pchb1 at pci0 dev 0 function 1 "ServerWorks CNB20LE Host" rev 0x06
> pci1 at pchb1 bus 1
> vga1 at pci0 dev 1 function 0 "ATI Rage XL" rev 0x27
> wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
> wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
> fxp0 at pci0 dev 4 function 0 "Intel 82557" rev 0x08, i82559: apic 5 int 4
> (irq
> 11), address 00:e0:81:01:cb:ca
> inphy0 at fxp0 phy 1: i82555 10/100 PHY, rev. 4
> pcib0 at pci0 dev 15 function 0 "ServerWorks ROSB4 SouthBridge" rev 0x50
> pciide0 at pci0 dev 15 function 1 "ServerWorks OSB4 IDE" rev 0x00: DMA
> wd0 at pciide0 channel 0 drive 0: <Maxtor 6Y060L0>
> wd0: 16-sector PIO, LBA, 58644MB, 120103200 sectors
> wd0(pciide0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 2
> ohci0 at pci0 dev 15 function 2 "ServerWorks OSB4/CSB5 USB" rev 0x04: apic 4
> in
> t 10 (irq 10), version 1.0, legacy support
> usb0 at ohci0: USB revision 1.0
> uhub0 at usb0
> uhub0: ServerWorks OHCI root hub, rev 1.00/1.00, addr 1
> uhub0: 4 ports with 4 removable, self powered
> isa0 at pcib0
> isadma0 at isa0
> pckbc0 at isa0 port 0x60/5
> pckbd0 at pckbc0 (kbd slot)
> pckbc0: using irq 1 for kbd slot
> wskbd0 at pckbd0: console keyboard, using wsdisplay0
> pmsi0 at pckbc0 (aux slot)
> pckbc0: using irq 12 for aux slot
> wsmouse0 at pmsi0 mux 0
> pcppi0 at isa0 port 0x61
> midi0 at pcppi0: <PC speaker>
> spkr0 at pcppi0
> sysbeep0 at pcppi0
> npx0 at isa0 port 0xf0/16: using exception 16
> pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
> pccom0: console
> pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
> fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
> fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
> biomask 0 netmask 0 ttymask 0
> pctr: 686-class user-level performance counters enabled
> mtrr: Pentium Pro MTRR support
> dkcsum: wd0 matches BIOS drive 0x80
> root on wd0a
> rootdev=0x0 rrootdev=0x300 rawdev=0x302
> WARNING: / was not properly unmounted
> Stopped at apm_cpu_idle+0x4a: leal 0xfffffff4(%ebp),%esp
>
> PS
> *******
> db{0}> ps
> PID PPID PGRP UID S FLAGS WAIT COMMAND
> 12120 24238 24238 0 7 0x2004006 gzip
> 24238 24978 24238 0 3 0x2004086 piperd tar
> 24978 14077 24978 0 3 0x2004086 pause ksh
> 14077 286 14077 1000 3 0x2004086 pause ksh
> 286 13427 13427 1000 3 0x2000184 select sshd
> 13427 2111 13427 0 3 0x2004084 netio sshd
> 1338 1 1338 0 3 0x2004086 ttyin ksh
> 252 1 252 0 3 0x2004086 ttyin getty
> 25463 1 25463 0 3 0x2004086 ttyin getty
> 16238 1 16238 0 3 0x2004086 ttyin getty
> 1816 1 1816 0 3 0x2004086 ttyin getty
> 10733 1 10733 0 3 0x2004086 ttyin getty
> 4308 1 4308 0 3 0x2000084 select cron
> 2111 1 2111 0 3 0x2000084 select sshd
> 28870 1 28870 0 3 0x2040184 select sendmail
> 29920 1 29920 0 3 0x2000184 select inetd
> 7572 19905 19905 83 3 0x2000184 poll ntpd
> 19905 1 19905 0 3 0x2000084 poll ntpd
> 18307 7623 7623 73 3 0x2000184 poll syslogd
> 7623 1 7623 0 3 0x2000084 netio syslogd
> 11 0 0 0 3 0x2100204 crypto_wa crypto
> 10 0 0 0 3 0x2100204 aiodoned aiodoned
> 9 0 0 0 3 0x2100204 syncer update
> 8 0 0 0 3 0x2100204 cleaner cleaner
> 7 0 0 0 3 0x100204 reaper reaper
> 6 0 0 0 3 0x2100204 pgdaemon pagedaemon
> 5 0 0 0 3 0x2100204 pftm pfpurge
> 4 0 0 0 3 0x2100204 usbtsk usbtask
> 3 0 0 0 3 0x2100204 usbevt usb0
> 2 0 0 0 3 0x2100204 kmalloc kmthread
> 1 0 1 0 3 0x2004084 wait init
> 0 -1 0 0 3 0x2080204 scheduler swapper
>
> TRACE PROC 0
> *******************
> ddb{0}> trace
> apm_cpu_idle(0,0,0,0,0) at apm_cpu_idle+0x4a
>
> TRACE PROC 1
> *******************
> When I try switching to proc 1, using machine ddb 1, it hangs...
>
>
>
> Well, that's all folks - I hope someone can help me...
>
> Thanks
> Nick
