according to key_string_set_modifiers() in key-string.c, :bind-key -n s-enter send-key enter
On Fri, Jul 5, 2013 at 9:13 PM, patrick keshishian <[email protected]> wrote: > On Fri, Jul 5, 2013 at 5:56 PM, patrick keshishian <[email protected]> wrote: >> On Fri, Jul 5, 2013 at 5:52 PM, Nicholas Marriott >> <[email protected]> wrote: >>> Ok so Return and Shift-Return never did anything different, you are just >>> wondering why Shift-Return no longer sends the same as Return. >>> >>> This is because tmux now treats it as a separate key by turning on the >>> xterm modifyOtherKeys feature. This means you can bind Return and >>> Shift-Return separately in tmux itself. The extended keys are also sent >>> through to applications inside tmux if the xterm-keys option is turned >>> on. > > To get the old behavior back, I should do something resembling: > > :bind-key -n Shift+Enter send-key Enter > > If so, I'm not quit getting how to specify the Shift+Return/Enter > combination. tmux complains about "unknown key". > > help? :) > > --patrick > > >> So... is there anyway I can enable the old behavior? I scanned through >> the tmux man page prior to my initial post, didn't see anything >> obvious. I'll go re-read again, but if there is a quick hint you can >> offer, that would be appreciated! >> >> --patrick >> >> >>> >>> >>> On Fri, Jul 05, 2013 at 05:28:58PM -0700, patrick keshishian wrote: >>>> Hi, >>>> >>>> On Fri, Jul 5, 2013 at 5:07 PM, Nicholas Marriott >>>> <[email protected]> wrote: >>>> > What did Shift-Return used to send? Run cat outside tmux and tell me >>>> > what it shows when you press Shift-Return. >>>> >>>> Not sure what you mean by running "cat outside tmux". >>>> >>>> Running `hexdump -C' (within xterm) shows 0a sent with Return and >>>> Shift+Return: >>>> >>>> $ hexdump -C >>>> RET-> >>>> 00000000 52 45 54 2d 3e 0a |RET->.| >>>> 00000006 >>>> $ hexdump -C >>>> SHIFT+RET-> >>>> 00000000 53 48 49 46 54 2b 52 45 54 2d 3e 0a |SHIFT+RET->.| >>>> 0000000c >>>> >>>> >>>> Is that similar to what you were asking for? >>>> >>>> --patrick >>>> >>>> >>>> > On Fri, Jul 05, 2013 at 03:42:39PM -0700, patrick keshishian wrote: >>>> >> Hi, >>>> >> >>>> >> Was running 2013-FEB-12 amd64 snapshot. Installed 2013-JUN-27 amd64 >>>> >> snapshot a couple of days ago. >>>> >> >>>> >> Immediately noticed that Shift+Return combination isn't being sent to >>>> >> the shell. I can't quite tell where/when this changed. Any ideas? >>>> >> >>>> >> --patrick
