Hello,
Stephan A. Rickauer wrote:
ugen0 at uhub4 port 1
ugen0: ASIX Electronics AX88178, rev 2.00/0.01, addr 2
I guess I _was_ unlucky. It's a Level one usb-0200.
Seems I was to quick. axe(4) should be the right one ... I'll try.
I am stuck now. All I could find out was that I have this device
connected at hub4, which theoretically is supported by the axe driver:
Controller /dev/usb4:
addr 1: high speed, self powered, config 1, EHCI root hub(0x0000),
Intel(0x8086), rev 1.00
uhub4
port 1 addr 2: high speed, power 450 mA, config 1, AX88178(0x1780),
ASIX Electronics(0x0b95), rev 0.01
ugen0
But I have no clue whether the desirable axe0 should have been created
automatically or whether I have to do that. I've read the usb, axe and
ugen man pages and searched the openbsd website but it's unclear to me
what I am supposed to do now. At the end I'd like to be able to
configure the device using ifconfig.
Please help me. Thanks.
--
Stephan A. Rickauer
----------------------------
Institut f|r Neuroinformatik
Universitdt / ETH Z|rich
Winterthurerstriasse 190
CH-8057 Z|rich
Tel: +41 44 635 30 50
Sek: +41 44 635 30 52
Fax: +41 44 635 30 53
http://www.ini.ethz.ch
----------------------------
