Hello,
I have this old but useful Dell L400 running 5.4.
Today I was going to try -current and, to my utter surprise, while running
bsd.rd install, the xl0 interface couldn't receive any DHCPOFFER from the
dhcp server (while on the server the DHCPDISCOVER arrives, same as openbsd
console). I double checked the server config, tried on a stupid router,
still the same problem. All other devices which I attach are working.
Running manually dhclient from 5.4 works.
So I tried 5.6 bsd.rd: the same problem. 5.5 bsd.rd: same problem. 5.4
bsd.rd: IT WORKS! (so no NIC failure)
It looks like that there was some regression between 5.4 and 5.5 that
caused this dhclient misbehaviour.
Here follows dmesg, thanks.
OpenBSD 5.4 (GENERIC) #37: Tue Jul 30 12:05:01 MDT 2013
[email protected]:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Intel Pentium III ("GenuineIntel" 686-class) 698 MHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PSE36,MMX,FXSR,SSE,PERF
real mem = 267907072 (255MB)
avail mem = 252076032 (240MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 05/09/03, BIOS32 rev. 0 @ 0xfd7a0,
SMBIOS rev. 2.3 @ 0xdc010 (28 entries)
bios0: vendor Quanta Computer version "A09(Q3J01)" date 05/09/2001
bios0: Dell Computer Corp. Latitude L400
apm0 at bios0: Power Management spec V1.2
acpi at bios0 function 0x0 not configured
pcibios0 at bios0: rev 2.1 @ 0xfd7a0/0x860
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfdf40/160 (8 entries)
pcibios0: PCI Interrupt Router at 000:07:0 ("Intel 82371FB ISA" rev 0x00)
pcibios0: PCI bus #2 is the last bus
WARNING: can't reserve area for I/O APIC.
bios0: ROM list: 0xc0000/0x10000 0xd0000/0x800! 0xdc000/0x4000!
cpu0 at mainbus0: (uniprocessor)
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "Intel 82443BX AGP" rev 0x03
intelagp0 at pchb0
agp0 at intelagp0: aperture at 0xf8000000, size 0x4000000
ppb0 at pci0 dev 1 function 0 "Intel 82443BX AGP" rev 0x03
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "ATI Mobility 1" rev 0x64
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
piixpcib0 at pci0 dev 7 function 0 "Intel 82371AB PIIX4 ISA" rev 0x02
pciide0 at pci0 dev 7 function 1 "Intel 82371AB IDE" rev 0x01: DMA, channel
0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <FUJITSU MHV2080AH>
wd0: 16-sector PIO, LBA, 76319MB, 156301488 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
pciide0: channel 1 disabled (no drives)
uhci0 at pci0 dev 7 function 2 "Intel 82371AB USB" rev 0x01: irq 11
piixpm0 at pci0 dev 7 function 3 "Intel 82371AB Power" rev 0x03: SMI
iic0 at piixpm0
spdmem0 at iic0 addr 0x50: 256MB SDRAM non-parity PC100CL2
clct0 at pci0 dev 8 function 0 "Cirrus Logic CS4281 CrystalClear" rev 0x01
irq 10
ac97: codec id 0x43525914 (Cirrus Logic CS4297A rev 4)
ac97: codec features headphone, 20 bit DAC, 18 bit ADC, Crystal Semi 3D
audio0 at clct0
cbb0 at pci0 dev 10 function 0 "TI PCI1410 CardBus" rev 0x01: irq 10
xl0 at pci0 dev 13 function 0 "3Com 3c905C 100Base-TX" rev 0x78: irq 10,
address 00:06:5b:37:34:b5
bmtphy0 at xl0 phy 24: 3C905C internal PHY, rev. 7
"AT&T/Lucent LTMODEM" rev 0x01 at pci0 dev 16 function 0 not configured
isa0 at piixpcib0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
pms0: Synaptics clickpad, firmware 4.1
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
usb0 at uhci0: USB revision 1.0
uhub0 at usb0 "Intel UHCI root hub" rev 1.00/1.00 addr 1
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 2 device 0 cacheline 0x8, lattimer 0x20
pcmcia0 at cardslot0
mtrr: Pentium Pro MTRR support
vscsi0 at root
scsibus0 at vscsi0: 256 targets
softraid0 at root
scsibus1 at softraid0: 256 targets
root on wd0a (a595f8c661d4bab3.a) swap on wd0b dump on wd0b
ath0 at cardbus0 dev 0 function 0 "Atheros AR5212" rev 0x01: irq 10
ath0: AR5213 5.6 phy 4.1 rf5111 1.7 rf2111 2.3, FCC2A*, address
00:02:6f:20:16:b7
