Not the end of the world, I was trying to see if I could boot OpenBSD on
this version of the EdgeRouter Pro from Ubiquiti. I try the latest
Octeon available just in case.
I am still trying, but start to run out of idea and i do need to get
some sleep now.
Anyone have a possible Idea as what I may try to load this may be.
Look like the processor may not be configure here, or may be I don't
read it right:
Anyway, this all from the start at the boot and then when it crash, it
retry to boot and then keep cycling in.
I just wanted to give this a trill as the box is nice and have 8 Gb
ports, of witch 2 can also be SFP in a very small 1U may be 7 inch deep.
Anyway, here it is.
==============================
Octeon ubnt_e200# resetJumping to start of image at address 0xbfca0000
U-Boot 2012.04.01 (UBNT Build ID: 4670715-g7c4b1d0) (Build time: May 27
2014 - 11:19:05)
Skipping PCIe port 0 BIST, in EP mode, can't tell if clocked.
Skipping PCIe port 1 BIST, reset not done. (port not configured)
BIST check passed.
UBNT_E200 r1:0, r2:15, serial #: 44D9E7410ECB
MPR 13-00317-15
Core clock: 1000 MHz, IO clock: 600 MHz, DDR clock: 533 MHz (1066 Mhz DDR)
Base DRAM address used by u-boot: 0x8f800000, size: 0x800000
DRAM: 2 GiB
Clearing DRAM...... done
Flash: 8 MiB
Net: octeth0, octeth1, octeth2, octeth3, octeth4, octeth5, octeth6,
octeth7
MMC: Octeon MMC/SD0: 0
USB: USB EHCI 1.00
scanning bus for devices... 2 USB Device(s) found
Type the command 'usb start' to scan for USB storage devices.
Hit any key to stop autoboot: 0
(Re)start USB...
USB: USB EHCI 1.00
scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
reading bsd.rd
7568951 bytes read
Allocating memory for ELF segment: addr: 0xffffffff81000000 (adjusted
to: 0x1000000), size 0x768c20
## Loading big-endian Linux kernel with entry point: 0xffffffff81000000 ...
Bootloader: Done loading app on coremask: 0x1
Starting cores 0x1
Total DRAM Size 0x0000000080000000
Bank 0 = 0x000000000176C000 -> 0x000000000FFFFFFF
Bank 1 = 0x0000000410000000 -> 0x000000041FFFFFFF
Bank 2 = 0x0000000020000000 -> 0x000000007FFFC001
mem_layout[0] page 0x00000000000005DB -> 0x0000000000003FFF
mem_layout[1] page 0x0000000000008000 -> 0x000000000001FFFF
mem_layout[2] page 0x0000000000104000 -> 0x0000000000107FFF
boot_desc->argv[1] = rootdev=/dev/sd0
Initial setup done, switching console.
boot_desc->desc_ver:7
boot_desc->desc_size:400
boot_desc->stack_top:0
boot_desc->heap_start:0
boot_desc->heap_end:0
boot_desc->argc:2
boot_desc->flags:0x5
boot_desc->core_mask:0x1
boot_desc->dram_size:2048
boot_desc->phy_mem_desc_addr:0
boot_desc->debugger_flag_addr:0xc84
boot_desc->eclock:1000000000
boot_desc->boot_info_addr:0x1001f0
boot_info->ver_major:1
boot_info->ver_minor:3
boot_info->stack_top:0
boot_info->heap_start:0
boot_info->heap_end:0
boot_info->boot_desc_addr:0
boot_info->exception_base_addr:0x1000
boot_info->stack_size:0
boot_info->flags:0x5
boot_info->core_mask:0x1
boot_info->dram_size:2048
boot_info->phys_mem_desc_addr:0x48108
boot_info->debugger_flags_addr:0
boot_info->eclock:1000000000
boot_info->dclock:533000000
boot_info->board_type:20003
boot_info->board_rev_major:0
boot_info->board_rev_minor:15
boot_info->mac_addr_count:8
boot_info->cf_common_addr:0
boot_info->cf_attr_addr:0
boot_info->led_display_addr:0
boot_info->dfaclock:0
boot_info->config_flags:0x8
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2015 OpenBSD. All rights reserved.
http://www.OpenBSD.org
OpenBSD 5.8-current (RAMDISK) #1: Thu Nov 26 17:33:10 CET 2015
jas...@erl-2.jasper.la:/usr/src/sys/arch/octeon/compile/RAMDISK
real mem = 2122907648 (2024MB)
avail mem = 2106032128 (2008MB)
mainbus0 at root
cpu0 at mainbus0: Cavium OCTEON II CPU rev 0.1 1000 MHz, Software FP
emulation
cpu0: cache L1-I 512KB D 8KB 64 way, L2 1024KB 8 way
clock0 at mainbus0: int 5
iobus0 at mainbus0
dwctwo0 at iobus0 base 0x1180068000000 irq 56cn30xxgmx0 at iobus0 base
0x1180008000000 irq 48
unsupported octeon model: 0xd9301
uar: ns16550, no working fifo
com0: console
com1 at uartbus0 base 0x1180000000c00 irq 35: ns16550, no working fifo
root on rd0a swap on rd0b dump on rd0b
WARNING: No TOD clock, believing file system.
WARNING: CHECK AND RESET THE DATE!
panic: pool_do_get: filepl free list modified: page 0x980000041e984000;
item addr 0x980000041e984000; offset 0x0=0x0 != 0xc45e62ccb6b162fe
syncing disks... done
System restart.
�Jumping to start of image at address 0xbfca0000
U-Boot 2012.04.01 (UBNT Build ID: 4670715-g7c4b1d0) (Build time: May 27
2014 - 11:19:05)
