On Thu, Feb 8, 2018, at 7:02 AM, Mihai Popescu wrote:
> > Then i setup only one port using configure command all ports work normally.
> I worked a lot with multiple RS-232 ports boards. They all had some
> hardware jumpers to configure the IRQ and Address for each port ( a
> lot of jumpers!). Maybe this option is integrated in your board BIOS,
> check it.
> How did you manage to find and even install 3.8 ?

The question is not how it is why. :)
I have sitting next to me every CD going back to 3.3.
If I were to dig a bit I am sure I  could find even earlier ones.

Reply via email to