Hi Henry, Im not sure that is possible .. man ospfd.conf does not yeild typically we just set the MTU of attached interfaces to a particular LAN to a value that is supported by by all devices attached to that lan...
if you are enabling Jumbo frames on an interface make sure that the switch that is interconnecting the devices also supports jumbo frames of that size (and has jumbo frames enabled) you can force the MTU to a value using ifconfig or hostname.if configuration files I hope this helps Tom Smyth On Mon, 14 Jan 2019 at 20:29, Henry Bonath <[email protected]> wrote: > Is it possible to set to ignore MTU on OpenOSPFD? > > For example on Cisco IOS I can add the command "ip ospf mtu-ignore" > > I am having some issues if the MTU is mismatched and some neighbors will be > stuck in Exstart or Exchange. > Other times those neighbors work fine, and it's unclear whether the MTU is > coming into play, however those neighbors do have MTU of 9000. > > Thanks in advance. > -- Kindest regards, Tom Smyth Mobile: +353 87 6193172 The information contained in this E-mail is intended only for the confidential use of the named recipient. If the reader of this message is not the intended recipient or the person responsible for delivering it to the recipient, you are hereby notified that you have received this communication in error and that any review, dissemination or copying of this communication is strictly prohibited. If you have received this in error, please notify the sender immediately by telephone at the number above and erase the message You are requested to carry out your own virus check before opening any attachment.
