When I disable PF and use tcpdump to monitor network activity on em2 (where the IPTV box is connected) I see a stream of udp packets (something like this: 233.33.210.7:5050) This stream is interrupted in several seconds when I enable PF again.
-- Best regards Maksim Rodin 17.06.2019, 10:20, "Peer" <p...@pjk.de>: > Could it be that your IPTV is using a non-IP protocoll, e.g. an ethertype > which is not IPv4 nor IPv6, but something different? Like Powerline, G.hn or > so? -- And which is blocked by pf?There are several protocol and type fields > on the different layers (MAC, IP, TCP/UDP), and I recently noticed that tools > and man pages do not always identify them very clearly or are somewhat > misnamed (for historical reasons I'd say).Btw., I'm looking for a pointer to > packet formats of ethertypes 0x88e1 and 0x8912, which my current filter > bubble or info availability didn't allow me to find until now. They show up > in tcpdump although they are not TCP nor even IP, and wireshark doesn't > decrypt the payload, which I'm interested in. > -------- Ursprüngliche Nachricht --------Von: Родин Максим > <a23s4a2...@yandex.ru> Datum: 16.06.19 22:16 (GMT+01:00) An: OpenBSD general > usage list <misc@openbsd.org> Betreff: [misc] IPTV handling on OpenBSD soft > router Hello,I am trying to set up an IPTV-box behind a soft router.When my > internet (iptv) provider installed the IPTV box he said thatI need a switch > before my soft router to let IPTV stream successfully pass to the IPTV box.I > thought that a virtual bridge interface would be enough for this purpose.I > created a bridge0 interface and added three interfaces to it:em0 - a physical > one which delivers internet and iptv from my provider.em2 - a physical one to > which the IPTV-box is connected and which receives a mac binded ip address > from the local network of my provider(100.65.129.0/24).vether0 - a virtual > one which receives an external ip address from dhcp server of my provider (it > therefore belongs to egress group) and through which my home computers access > the internet using NAT ({ vether1 em1 em3 athn0 }).When PF is disabled the > IPTV-box is working.When PF is enabled the IPTV box works for several seconds > and then the picture freezes. When I change to another TV channel it works > again for several seconds and then it freezes again.My pf settings are listed > below (I used some of the config in PF user's guide)I do no filtering on the > ports needed (em0, em2)When I do:tcpdump -n -e -i pflog0 not ifname vether0It > shows no blocked packetsWhat am I > missing?""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""router > root ~ # cat /etc/pf.conf# $OpenBSD: pf.conf,v 1.54 2014/08/23 05:49:42 > deraadt Exp $## See pf.conf(5) and /etc/examples/pf.confint_if = "{ vether1 > em1 em3 athn0 }"table <martians> { 0.0.0.0/8 10.0.0.0/8 127.0.0.0/8 > 169.254.0.0/16 \ 172.16.0.0/12 192.0.2.0/24 224.0.0.0/3 \ > 192.168.0.0/16 198.18.0.0/15 198.51.100.0/24 \ 203.0.113.0/24 > }table <bad_ips> persist file "/etc/pf/bad_ip"block log allset block-policy > dropset loginterface egressset skip on lomatch out on egress inet from > (vether1:network) to any nat-to (egress:0)block in quick on egress from > <martians> to anyblock return out quick on egress from any to <martians>pass > out quick inetpass in on $int_if inet# IPTVpass on em2pass on em0#pass in on > egress inet proto tcp from !<bad_ips> to (egress) port 22pass in on egress > inet proto tcp from !<bad_ips> to (egress) port 80pass in on egress inet > proto { tcp udp } from any to (egress) port { 51413 22034 6890:6999 6881 } > rdr-to 192.168.1.4pass in on egress inet proto { tcp udp } from any to > (egress) port { 50000 } rdr-to 192.168.1.65#block return # block stateless > traffic#pass # establish keep-state# By default, do not permit remote > connections to X11#block return in on ! lo0 proto tcp to port > 6000:6010""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""" -- > Best regardsMaksim Rodin