On Tue, Jun 25, 2019 at 12:06:51AM +0300, 3 wrote: > i know that wifi adapters never worked in obsd(excluding those > adapters for which drivers were written by vendors), but i found one > that shows signs of life in 11n(11ac 2t2r supported by chip). it can > be bought anywhere where there are samsung tv. moreover it even works > in hostap mode(unlike the buggy athn). > but without a ton of bugs not done: > bwfm0: could not read register: TIMEOUT > bwfm0: could not open rx pipe: IN_USE > bwfm0: could not init bus > bwfm0: firmware did not start up > .and sometimes kernel panic on boot, but works would still! > meet https://wikidevi.com/wiki/Samsung_WCH730B > bwfm0 at uhub0 port 1 configuration 1 interface 0 "Broadcom BCMUSB 802.11 > Wireless Adapter" rev 2.10/0.01 addr 2 > photo without cover: http://pichost.org/images/2019/06/24/Untitled-138.jpg > it is shown where to solder the wires for wifi. on the right through > two pins(ground is first) is bluetooth, but for obsd this does not > matter(thx theo). > data sheet for chip: https://www.cypress.com/file/310246/download
Did you solder that yourself? As long as nothing has changed, bwfm(4) on USB worked fine with the one USB one that I had: The official raspberry Pi USB WiFi stick that they sold before they put the WiFi chip onto the board itself. I wouldn't blame that on the driver. Did you try the stick with Linux? If it works with Linux then maybe it's my fault after all. Patrick
