On 15.12.2019. 23:01, Hrvoje Popovski wrote: > On 15.12.2019. 12:45, Holger Glaess wrote: >> hi >> >> >> runing version >> >> >> /etc 16>dmesg | more >> Copyright (c) 1982, 1986, 1989, 1991, 1993 >> The Regents of the University of California. All rights reserved. >> Copyright (c) 1995-2019 OpenBSD. All rights reserved. >> https://www.OpenBSD.org >> >> OpenBSD 6.6-current (GENERIC.MP) #48: Tue Dec 10 16:30:01 MST 2019 >> dera...@octeon.openbsd.org:/usr/src/sys/arch/octeon/compile/GENERIC.MP >> >> >> >> after a reboot the aggr interface do not aggregate the connection with >> the switch, >> >> just after an physical disaconnection from the ethernet cable , wait for >> some sec, >> >> and replugin . >> >> >> the the iterface are up and active, before ifconfig says "no carrier" >> but the interfaces have >> >> carrier. >> >> i dont have the problem with the trunk interface on the same hardware. >> >> >> you are on bellab as root >> /etc 20>cat /etc/hostname.cnmac1 >> mtu 1518 >> up >> >> 12:43:59 Sun Dec 15 >> you are on bellab as root >> /etc 21>cat /etc/hostname.cnmac2 >> mtu 1518 >> up >> >> 12:44:01 Sun Dec 15 >> you are on bellab as root >> /etc 22>cat /etc/hostname.aggr0 >> trunkport cnmac1 >> trunkport cnmac2 >> mtu 1518 >> up >> >> >> holger >> >> >> > Hi, > > maybe logs below would help for further troubleshooting because i'm > seeing same behavior. > > when i add debug statement in hostname.agg0 and boot box i'm getting > this log > > starting network > aggr0 ix0 rxm: LACP_DISABLED (LACP_Enabled) -> PORT_DISABLED > aggr0 ix0: selection logic: unselected (rxm !CURRENT) > aggr0 ix1 rxm: LACP_DISABLED (LACP_Enabled) -> PORT_DISABLED > aggr0 ix1: selection logic: unselected (rxm !CURRENT) > aggr0 ix2 rxm: LACP_DISABLED (LACP_Enabled) -> PORT_DISABLED > aggr0 ix2: selection logic: unselected (rxm !CURRENT) > aggr0 ix3 rxm: LACP_DISABLED (LACP_Enabled) -> PORT_DISABLED > aggr0 ix3: selection logic: unselected (rxm !CURRENT) > reordering libraries: done. > > after boot aggr status is "no carrier" > sh /etc/netstart isn't helping > > but with ifconfig ix0-ix4 down/up aggr interface start to work normally > > log when doing ifconfig ix0-ix4 down/up
just a little follow up: i've tested aggr on two boxes. first box is dell r620 and second one is supermicro SYS-5018D-FN8T. both boxes are connected to dell s4810 switch. Same cables, same ports, same port-channles on switch, timeout fast or slow, both with ix 82599 interfaces ... (x552 ix interfaces are disabled on supermicro box) ... r620 is working without any problems and supermicro box is having same problem as described above... trunk interface are working on both boxes without any problem .. this is fun :)
