On Wed, Feb 17, 2021 at 12:08:52PM +0100, Raimo Niskanen wrote: > Hello misc! > > I have problem booting an APU2 from SD card and USB stick. > It boots fine from the mSATA disk where I have the OpenBSD installation > that I have upgraded several times using sysupgrade(8). > > I have tried to write install67.fs and install68.img to an SD card and to > an USB stick from a Linux machine using e.g > dd if=install67.fs of=/dev/sdc bs=1M > > On the APU:s serial console, I press [F10] to get a boot prompt, and then > select the SD card or the USB stick. The kernel is loaded and the last > printout is "Entry point: 0xffff..." something. The next line > [ELF ... whatnot] does not come. After a while the APU resets and boots > again, or sometimes hangs.
Before loading a kernel the serial console needs to be enabled with: stty com0 115200 set tty com0 On an installed system /etc/boot.conf is usually set up to do this automatically but manual setup is still required when booting from other media.
