Hi,
it crashed again.
Here is the dmesg, this time the kernel had debugging symbols enabled.
[...]
ic0 at ichiic0
spdmem0 at iic0 addr 0x50: 2GB DDR3 SDRAM PC3-12800 SO-DIMM
isa0 at pcib0
isadma0 at isa0
vga0 at isa0 port 0x3b0/48 iomem 0xa0000/131072
wsdisplay at vga0 not configured
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
wbsio0 at isa0 port 0x2e/2: NCT5104D rev 0x53
wbsio0 port 0xa10/2 not configured
vmm0 at mainbus0: VMX/EPT
run0 at uhub0 port 4 configuration 1 interface 0 "Ralink 802.11 n WLAN" rev 2.0
0/1.01 addr 2
run0: MAC/BBP RT5592 (rev 0x0222), RF RT5592 (MIMO 2T2R), address d8:61:62:37:5
6:c8
uhub2 at uhub1 port 1 configuration 1 interface 0 "Intel Rate Matching Hub" rev
2.00/0.04 addr 2
vscsi0 at root
scsibus2 at vscsi0: 256 targets
softraid0 at root
scsibus3 at softraid0: 256 targets
root on sd0a (7ec83d15890e2a71.a) swap on sd0b dump on sd0b
inteldrm0: 1024x768, 32bpp
wsdisplay0 at inteldrm0 mux 1
wsdisplay0: screen 0-5 added (std, vt100 emulation)
kernel: protection fault trap, code=0
Stopped at icmp_mtudisc_timeout+0x77 [/usr/src/sys/netinet/ip_icmp.c:1072]
: movq 0(%rax),%rcx
ddb{0}> ddb{0}>
ddb{0}> bt
icmp_mtudisc_timeout(fffffd807a4e0620,0) at icmp_mtudisc_timeout+0x77 [/usr/src
/sys/netinet/ip_icmp.c:1072]
rt_timer_timer(ffffffff82324248) at rt_timer_timer+0x1cc [/usr/src/sys/net/rout
e.c:1551]
softclock_thread(ffff8000fffff260) at softclock_thread+0x13b [/usr/src/sys/kern
/kern_timeout.c:681]
end trace frame: 0x0, count: -3
ddb{0}> call db_show_rtentry(fffffd807a4e0620, 0, 0)
Symbol not found
I'd love to know whats going wrong here.
Best regards,
Stephan
