This is current/octeon on an Ubiquity Secure Gateway (dmesg below).
Everything seems to work; even if the whole machine is a bit slow,
it compiles a kernel and runs fine (off a 16GB USB stick).
Looking at the cereal console during boot, I see
U-Boot 1.1.1 (UBNT Build ID: 4674499-gfa58f5d) (Build time: Jun 9 2014 -
14:38:01)
That seems old; is there a way to upgrade das U-Boot on the octeon?
(And is there acutaly anything to be gained by doing that?)
Looking at pkg_info -Q boot,
none of those seems to be for octeon.
Thank you for putting my old HW to work.
Jan
[ using 779816 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2025 OpenBSD. All rights reserved. https://www.OpenBSD.org
OpenBSD 7.8-current (GENERIC.MP) #0: Sun Dec 21 14:47:02 CET 2025
[email protected]:/usr/src/sys/arch/octeon/compile/GENERIC.MP
real mem = 536870912 (512MB)
avail mem = 520880128 (496MB)
random: good seed from bootblocks
mainbus0 at root: board 20004 rev 0.17, model CN3xxx/CN5xxx
cpu0 at mainbus0: CN50xx CPU rev 0.1 500 MHz, Software FP emulation
cpu0: cache L1-I 32KB 4 way D 16KB 64 way, L2 128KB 8 way
cpu1 at mainbus0: CN50xx CPU rev 0.1 500 MHz, Software FP emulation
cpu1: cache L1-I 32KB 4 way D 16KB 64 way, L2 128KB 8 way
clock0 at mainbus0: int 5
octcrypto0 at mainbus0
iobus0 at mainbus0
simplebus0 at iobus0: "soc"
octciu0 at simplebus0
octsmi0 at simplebus0
octpip0 at simplebus0
octgmx0 at octpip0 interface 0
cnmac0 at octgmx0: port 0 RGMII, address 74:ac:b9:38:fd:c2
atphy0 at cnmac0 phy 7: AR8035, rev. 2
cnmac1 at octgmx0: port 1 RGMII, address 74:ac:b9:38:fd:c3
atphy1 at cnmac1 phy 6: AR8035, rev. 2
cnmac2 at octgmx0: port 2 RGMII, address 74:ac:b9:38:fd:c4
atphy2 at cnmac2 phy 5: AR8035, rev. 2
com0 at simplebus0: ns16550a, 64 byte fifo
com0: console
dwctwo0 at iobus0 base 0x1180068000000 irq 56
usb0 at dwctwo0: USB revision 2.0
uhub0 at usb0 configuration 1 interface 0 "Octeon DWC2 root hub" rev 2.00/1.00
addr 1
octrng0 at iobus0 base 0x1400000000000 irq 0
umass0 at uhub0 port 1 configuration 1 interface 0 "USB Flash Disk" rev
2.10/11.00 addr 2
umass0: using SCSI over Bulk-Only
scsibus0 at umass0: 2 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0: <USB, Flash Disk, 1100> removable
sd0: 15200MB, 512 bytes/sector, 31129600 sectors
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
root on sd0a (1e5741621788e04e.a) swap on sd0b dump on sd0b
WARNING: CHECK AND RESET THE DATE!
