Hi,
It must have been too long ago since I built routers under BSD. I got three
subnets in a series below the internet connection and cannot add a proper
route between subnet 1 and 3.
The subnets are as follows:
{Internet}
|
Subnet 1: 10.1.1
|
Subnet 2: 192.168.1
|
Subnet 3: 192.168.0
Router 1: int if = 10.1.1.1
Router 2: ext if = 10.1.1.2 int if = 192.168.1.254
Router 3: ext if = 192.168.1.253 int if = 192.168.0.254
On the second router I have these routes up:
(Note the H in 192.168.0.0 but I need a -net.)
Destination Gateway Flags Refs Use Mtu Interface
default 10.1.1.1 UGS 0 6014 - xl0
10.1.1/24 link#2 UC 0 0 - xl0
10.1.1.1 00:00:00:00:00:f1 UHLc 0 0 - xl0
127/8 127.0.0.1 UGRS 0 0 33224 lo0
127.0.0.1 127.0.0.1 UH 0 30 33224 lo0
192.168.0.0 192.168.1.254 UGHS 0 0 - dc0
192.168.1/24 link#1 UC 0 0 - dc0
224/4 127.0.0.1 URS 0 0 33224 lo0
Sitting on the second router (above), I cannot get it to route to subnet
192.168.0. As you can see below.
route get 192.168.0.1
route to: 192.168.0.1
destination: default
mask: default
gateway: 10.1.1.1
interface: xl0
if address: 10.1.1.2
flags: <UP,GATEWAY,DONE,STATIC>
recvpipe sendpipe ssthresh rtt,msec rttvar hopcount mtu
expire
0 0 0 0 0 0 0 0
I've tried numerous route commands but it never results in routing it down to
198.168.0. My last routing commands looks like this:
route add 192.168.0 192.168.1.253
route add 192.168.0.254 192.168.1.253
What is the route command supposed to look like to route down to 192.168.0?
--
Steve
"They that would give up essential liberty for temporary safety
deserve neither liberty nor safety."
Benjamin Franklin
