On Wed, Oct 31, 2007 at 02:05:12PM +0200, Denis Doroshenko wrote:
> yesterday i brought my test notebook to the -current (at the moment it
> was somewhere a week back). after that i experience that Atheros WiFi
> interface degraded, dhclient does not work since then and if i
> configure it by hand the traffic transfer is rather poor (4 KB/s now
> vs. 150 KB/s then). Can it be related to source changes to the code
> for atheros chips? If any info needed i will provide it.
>
hmmm... thanks.
is it possible for you to try:
- with latest version from HEAD
- with a version from 2007/10/28 (before tx descriptor changes)
- with a version from 2007/10/11 (before channel offset changes)
for the following files:
src/sys/dev/ic/ar5xxx.c
src/sys/dev/ic/ar5xxx.h
src/sys/dev/ic/ar5210.c
src/sys/dev/ic/ar5210reg.h
src/sys/dev/ic/ar5210var.h
src/sys/dev/ic/ar5211.c
src/sys/dev/ic/ar5211reg.h
src/sys/dev/ic/ar5211var.h
src/sys/dev/ic/ar5212.c
src/sys/dev/ic/ar5212reg.h
src/sys/dev/ic/ar5212var.h
src/sys/dev/ic/ath.c
src/sys/dev/ic/athvar.h
send me the output of (for each):
- ifconfig -M ath0
- dmesg
- tcpdump -y ieee802_11_radio -evni ath0
- try "ifconfig ath0 debug" to get verbose info in dmesg
reply in private
reyk
> OpenBSD 4.2-current (GENERIC) #0: Tue Oct 30 09:16:32 EET 2007
> [EMAIL PROTECTED]:/data/src/sys/arch/i386/compile/GENERIC
> cpu0: Intel(R) Pentium(R) M processor 1600MHz ("GenuineIntel"
> 686-class) 1.60 GHz
> cpu0:
> FPU,V86,DE,PSE,TSC,MSR,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,CFLUSH,DS,ACPI,MMX,FXSR,SSE,SSE2,TM,SBF,EST,TM2
> real mem = 536244224 (511MB)
> avail mem = 510722048 (487MB)
> mainbus0 at root
> bios0 at mainbus0: AT/286+ BIOS, date 12/12/03, BIOS32 rev. 0 @
> 0xf0000, SMBIOS rev. 2.3 @ 0xff0dc (29 entries)
> bios0: vendor Hewlett-Packard version "68BDD Ver. F.09" date 12/12/2003
> bios0: Hewlett-Packard HP Compaq nc6000 (DJ256A#ABB)
> apm0 at bios0: Power Management spec V1.2 (BIOS managing devices)
> apm0: AC on, battery charge unknown
> pcibios0 at bios0: rev 2.1 @ 0xf0000/0x2000
> pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xf0840/160 (8 entries)
> pcibios0: bad IRQ table checksum
> pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xf51c0/160 (8 entries)
> pcibios0: PCI Exclusive IRQs: 5 10 11
> pcibios0: PCI Interrupt Router at 000:31:0 ("Intel 82801DBM LPC" rev 0x00)
> pcibios0: PCI bus #5 is the last bus
> bios0: ROM list: 0xc0000/0x10000
> cpu0 at mainbus0
> cpu0: Enhanced SpeedStep 1600 MHz (1484 mV): speeds: 1600, 1400, 1200,
> 1000, 800, 600 MHz
> pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
> pchb0 at pci0 dev 0 function 0 "Intel 82855PE Hub" rev 0x03
> ppb0 at pci0 dev 1 function 0 "Intel 82855PE AGP" rev 0x03
> pci1 at ppb0 bus 1
> vga1 at pci1 dev 0 function 0 "ATI Radeon Mobility M10 NP" rev 0x00
> wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
> wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
> uhci0 at pci0 dev 29 function 0 "Intel 82801DB USB" rev 0x03: irq 10
> uhci1 at pci0 dev 29 function 1 "Intel 82801DB USB" rev 0x03: irq 10
> uhci2 at pci0 dev 29 function 2 "Intel 82801DB USB" rev 0x03: irq 10
> ehci0 at pci0 dev 29 function 7 "Intel 82801DB USB" rev 0x03: irq 10
> usb0 at ehci0: USB revision 2.0
> uhub0 at usb0 "Intel EHCI root hub" rev 2.00/1.00 addr 1
> ppb1 at pci0 dev 30 function 0 "Intel 82801BAM Hub-to-PCI" rev 0x83
> pci2 at ppb1 bus 2
> ath0 at pci2 dev 4 function 0 "Atheros AR5212" rev 0x01: irq 11
> ath0: AR5213 5.6 phy 4.1 rf5111 1.7 rf2111 2.3, WOR0W, address
> 00:0b:cd:5b:e0:32
> cbb0 at pci2 dev 6 function 0 "O2 Micro OZ711E0 CardBus" rev 0x00: irq 10
> cbb1 at pci2 dev 6 function 1 "O2 Micro OZ711E0 CardBus" rev 0x00: irq 10
> "O2 Micro OZ711Mx CardBus" rev 0x00 at pci2 dev 6 function 2 not configured
> cbb2 at pci2 dev 6 function 3 "O2 Micro OZ711E0 CardBus" rev 0x00: irq 10
> bge0 at pci2 dev 14 function 0 "Broadcom BCM5705M Alt" rev 0x03,
> BCM5705 A3 (0x3003): irq 11, address 00:14:38:1b:a7:61
> brgphy0 at bge0 phy 1: BCM5705 10/100/1000baseT PHY, rev. 2
> cardslot0 at cbb0 slot 0 flags 0
> cardbus0 at cardslot0: bus 3 device 0 cacheline 0x0, lattimer 0x20
> pcmcia0 at cardslot0
> cardslot1 at cbb1 slot 1 flags 0
> cardbus1 at cardslot1: bus 4 device 0 cacheline 0x0, lattimer 0x20
> pcmcia1 at cardslot1
> cardslot2 at cbb2 slot 2 flags 0
> cardbus2 at cardslot2: bus 5 device 0 cacheline 0x0, lattimer 0x20
> pcmcia2 at cardslot2
> ichpcib0 at pci0 dev 31 function 0 "Intel 82801DBM LPC" rev 0x03:
> 24-bit timer at 3579545Hz
> pciide0 at pci0 dev 31 function 1 "Intel 82801DBM IDE" rev 0x03: DMA,
> channel 0 configured to compatibility, channel 1 configu
> red to compatibility
> wd0 at pciide0 channel 0 drive 0: <HTS726060M9AT00>
> wd0: 16-sector PIO, LBA48, 57231MB, 117210240 sectors
> wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 5
> atapiscsi0 at pciide0 channel 1 drive 0
> scsibus0 at atapiscsi0: 2 targets
> cd0 at scsibus0 targ 0 lun 0: <TOSHIBA, DVD-ROM SD-R2512, 1A04> SCSI0
> 5/cdrom removable
> cd0(pciide0:1:0): using PIO mode 4, DMA mode 2
> auich0 at pci0 dev 31 function 5 "Intel 82801DB AC97" rev 0x03: irq
> 11, ICH4 AC97
> ac97: codec id 0x41445374 (Analog Devices AD1981B)
> ac97: codec features headphone, 20 bit DAC, No 3D Stereo
> audio0 at auich0
> "Intel 82801DB Modem" rev 0x03 at pci0 dev 31 function 6 not configured
> usb1 at uhci0: USB revision 1.0
> uhub1 at usb1 "Intel UHCI root hub" rev 1.00/1.00 addr 1
> usb2 at uhci1: USB revision 1.0
> uhub2 at usb2 "Intel UHCI root hub" rev 1.00/1.00 addr 1
> usb3 at uhci2: USB revision 1.0
> uhub3 at usb3 "Intel UHCI root hub" rev 1.00/1.00 addr 1
> isa0 at ichpcib0
> isadma0 at isa0
> pckbc0 at isa0 port 0x60/5
> pckbd0 at pckbc0 (kbd slot)
> pckbc0: using irq 1 for kbd slot
> wskbd0 at pckbd0: console keyboard, using wsdisplay0
> pms0 at pckbc0 (aux slot)
> pckbc0: using irq 12 for aux slot
> wsmouse0 at pms0 mux 0
> pcppi0 at isa0 port 0x61
> midi0 at pcppi0: <PC speaker>
> spkr0 at pcppi0
> lpt0 at isa0 port 0x378/4 irq 7
> npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
> pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
> pccom2 at isa0 port 0x3e8/8 irq 5: ns16550a, 16 byte fifo
> fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
> biomask e74d netmask ef4d ttymask ffcf
> mtrr: Pentium Pro MTRR support
> ugen0 at uhub3 port 1 "ACTIONTEC Bluetooth by hp" rev 1.10/8.02 addr 2
> dkcsum: wd0 matches BIOS drive 0x80
> root on wd0a swap on wd0b dump on wd0b
> ath0: device timeout
> ath0: device timeout
> ath0: device timeout
> ath0: device timeout
> ath0: device timeout
> ath0: device timeout
> ath0: device timeout
> ath0: device timeout
> ath0: device timeout
> ath0: device timeout
> ath0: device timeout
> ath0: device timeout
