Yes, I installed the firmware as it directs in the pgt man page (http://www.nazgul.ch/pgt/pgt-firmware-1.2.tgz - actually, the man page links to the 1.1 version of the firmware, but there is a 1.2 version available - which is what i used - i had the same problem (with the "not responding" message) when i installed the 1.1 version of the firmware earlier last week)
I posted my dmesg in a post last week (on 2/1) thanks -----Original Message----- From: Julien Cabillot [mailto:[EMAIL PROTECTED] Sent: Monday, February 04, 2008 3:32 PM To: [EMAIL PROTECTED] Subject: Re: OpenBSD 4.2 - Netgear WG511 pcmcia wireless card - notrespondiing Did you install the firmware ? cf. http://www.nabble.com/OpenBSD-4.2---Netgear-WG511-pcmcia-wireless-card---not -respondiing-td15232095.html On lun, 2008-02-04 at 15:21 -0600, Theodore Wynnychenko wrote: > Hi: > Last week I asked about the failure of OpenBSD to work with a wireless > pcmcia network card (WG511). > I hope the question is not too basic, but, is the misc list the wrong place > to ask the question? > Does anyone have any advice for me about this? > It seems the kernel correctly identifies the card on insertion, but then the > pgt firmware gives me a "not responding" message. Is the card dead? Am I > doing something wrong? Did I miss something during the install? > I have spent the better part of a week going through the man pages, the > mailing list archive, the faq, and searching with google; but, am unable to > even come up with a direction to go. > If anyone has any ideas, I would really appreciate it. Is this the wrong > place to ask my question? If so, could someone let me know that is the > case. > Thanks again
