On 2008-02-24, Rolf Sommerhalder <[EMAIL PROTECTED]> wrote:
> The kernel "4.3 GENERIC#662 i386" from the latest snapshot fails to
> boot on WRAP, whereas it boots fine on ALIX and on other i386
> machines. Whereas the kernel from the previous snapshot "4.3
> GENERIC#661 i386" boots fine on WRAP and others, such as ALIX.
I couldn't find a copy of #662 but I don't see this with #663 on my WRAP...
PC Engines WRAP.1C/1D/1E v1.11
640 KB Base Memory
130048 KB Extended Memory
01F0 Master 848A 64MB CHH
Phys C/H/S 978/4/32 Log C/H/S 978/4/32
Using drive 0, partition 3;
Loading;...
probing: pc0 com0 pci mem[640K 127M a20=on]
disk: hd0
>> OpenBSD/i386 BOOT 3.01
switching console to com0
>> OpenBSD/i386 BOOT 3.01
boot> testbsd
booting hd0a:testbsd: 5921584+873540 [52+307392+288398]=0x70c86c
entry point at 0x200120*
[ using 596216 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2008 OpenBSD. All rights reserved. http://www.OpenBSD.org
OpenBSD 4.3-beta (GENERIC) #663: Sat Feb 23 17:30:07 MST 2008
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Geode(TM) Integrated Processor by National Semi ("Geode by NSC"
586-class) 267 MHz
cpu0: FPU,TSC,MSR,CX8,CMOV,MMX
cpu0: TSC disabled
real mem = 133791744 (127MB)
avail mem = 121454592 (115MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 11/08/05, BIOS32 rev. 0 @ 0xfc622
acpi at bios0 function 0x0 not configured
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xe0000/0x8000
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "Cyrix GXm PCI" rev 0x00
puc0 at pci0 dev 13 function 0 "Oxford OXmPCI954" rev 0x00: ports: 3 com
pccom3 at puc0 port 0 irq 12: st16650, 32 byte fifo
pccom4 at puc0 port 1 irq 12: st16650, 32 byte fifo
pccom5 at puc0 port 2 irq 12: st16650, 32 byte fifo
"Oxford OXmPCI954 Disabled" rev 0x00 at pci0 dev 13 function 1 not configured
sis0 at pci0 dev 14 function 0 "NS DP83815 10/100" rev 0x00, DP83816A: irq 10,
address 00:0d:b9:04:92:d0
nsphyter0 at sis0 phy 0: DP83815 10/100 PHY, rev. 1
sis1 at pci0 dev 15 function 0 "NS DP83815 10/100" rev 0x00, DP83816A: irq 9,
address 00:0d:b9:04:92:d1
nsphyter1 at sis1 phy 0: DP83815 10/100 PHY, rev. 1
sis2 at pci0 dev 16 function 0 "NS DP83815 10/100" rev 0x00, DP83816A: irq 11,
address 00:0d:b9:04:92:d2
nsphyter2 at sis2 phy 0: DP83815 10/100 PHY, rev. 1
gscpcib0 at pci0 dev 18 function 0 "NS SC1100 ISA" rev 0x00
gpio0 at gscpcib0: 64 pins
"NS SC1100 SMI" rev 0x00 at pci0 dev 18 function 1 not configured
pciide0 at pci0 dev 18 function 2 "NS SCx200 IDE" rev 0x01: DMA, channel 0
wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <64MB CHH>
wd0: 1-sector PIO, LBA, 61MB, 125184 sectors
wd0(pciide0:0:0): using PIO mode 2
"NS SCx200 AUDIO" rev 0x00 at pci0 dev 18 function 3 not configured
geodesc0 at pci0 dev 18 function 5 "NS SC1100 X-Bus" rev 0x00: iid 6 revision 3
wdstatus 0
isa0 at gscpcib0
isadma0 at isa0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
gscsio0 at isa0 port 0x2e/2: SC1100 SIO rev 1: ACB1 ACB2
iic0 at gscsio0
iic1 at gscsio0
lmtemp0 at iic1 addr 0x48: lm77
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom0: console
biomask e1ef netmask efef ttymask ffef
nvram: invalid checksum
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
