[email protected] schrieb:
> sys:a -------SWITCH----OPENBSD/BRIDGE----SWITCH--------sys:b
> 192.168.1.2 (NO IPs) 192.168.1.10
>
> I have enabled bridging by doing the following:
>
>
> /etc/hostname.bge0
> up
> /etc/hostname.bge1
> up
>
> /etc/hostname.bridge0
> add bge0
> add bge1
> I have enabled ip forwarding in /etc/sysctl.conf
>
Hello,
did you verify your bridge is up ( with ifconfig).
I would say: no, as you would have seen no bridge interface (or the
bridge not being up).
The config file of bridge0 has to be
/etc/bridgename.bridge0 and you have to put an up at the end.
^^^^^^^^^^
This is one of the reasons for the following advice often written on
this list.
1. read the manual/faq
2. understand what is written there
3. re-read it again
In this cas it is the following faq:
http://www.openbsd.org/faq/faq6.html#Bridge
guido
> Shouldn't I see sys:a from sys:b???
>
>
> I can't see the sys:a from sys:b or sys:b from sys:a. It doesn't seem that
> openbsd/bridge is forwarding the packets to the other side.
>
>
> I would appreciate any help.
>
> **Sorry for the resend but rich text email was enabled. I just disabled
> it now.
