RJ45 wrote:
ok thank you for the configuration, but I have one more problem.
Your welcome.
aside vlan100 and vlan 101 I need to have i on physical vr1 vr2 vr3
but also the default native vlan (VLAN 1 UNTAGGED) needs to be forwarded
to vr1 vr2 vr3
I assume you wrote, that you want IP's on each interface.
My example show IP's on the physical interface dc0. If you want IP's on
them, put them on. Or I guess it might be better to create lo1, lo2, lo3
or what ever you want, put IP's on them and then make them part of the
vlan you want them in. Nothing say you can't have multiple lox
interfaces and use them as you want.
If you look at my example, the unlag vlan pass right through dc0 and dc1
via the bridge1 and then an other set of IP's on vlan 2 pass between the
same interface via bridge2.
So, what's really your problem here? Bridge all your interface on
bridge10 of you want and add a lox interface to it if you want that too.
Why not?
no I Can only do it adding physical vr1 vr2 vr3 to the bridge, and
after doing this everything is messed up....
Start by doing two interface setup. Then add one more, etc. It does work.
And then plug your dhcp on the vlan/bridge you want after that.
I sent you a working setup, so start from there and move on. I even run
pf on it too. That could be a little more tricky when you had more
interface, but still a good play ground to be on. (;>
Unless I really don't understand your question, witch I think I did
understand it. There isn't any problem doing what you want to do at all.
Do, one step, test and do the next and you will get there.
Hope it help you anyway, but I think you have all that you need now.
Best,
Daniel
