Hello, this is an example. Attached is a 1GB (fat!) usb memory stick. It took 40 minutes to copy 285M.
This one was Jan 19 21:18:04 hux /bsd: umass0: using SCSI over Bulk-Only Jan 19 21:18:04 hux /bsd: scsibus1 at umass0: 2 targets, initiator 0 Jan 19 21:18:04 hux /bsd: sd1 at scsibus1 targ 1 lun 0: <-Pretec, 01GB, 2.00> SCSI2 0/direct removable Jan 19 21:18:04 hux /bsd: sd1: 983MB, 512 bytes/sec, 2015231 sec total I will repeat the test with all other ports now. Thanks again T. # du -hs TEST/ 285M TEST/ # date && cp -r TEST/ /mnt && umount /mnt && date Tue Jan 19 21:20:01 CET 2010 Tue Jan 19 22:00:18 CET 2010 # usbdevs -v Controller /dev/usb0: addr 1: high speed, self powered, config 1, EHCI root hub(0x0000), Intel(0x8086), rev 1.00 port 1 powered port 2 powered port 3 powered port 4 powered port 5 powered port 6 powered Controller /dev/usb1: addr 1: high speed, self powered, config 1, EHCI root hub(0x0000), Intel(0x8086), rev 1.00 port 1 addr 2: high speed, power 80 mA, config 1, USB Mass Storage Device(0xba63), PRETEC 00, iSerialNumber 01AE0000000823 port 2 powered port 3 powered port 4 powered port 5 powered port 6 powered Controller /dev/usb2: addr 1: full speed, self powered, config 1, UHCI root hub(0x0000), Intel(0x8086), rev 1.00 port 1 powered port 2 powered Controller /dev/usb3: addr 1: full speed, self powered, config 1, UHCI root hub(0x0000), Intel(0x8086), rev 1.00 port 1 addr 2: full speed, power 100 mA, config 1, Fingerprint Sensor(0x2810), AuthenTec(0 port 2 powered Controller /dev/usb4: addr 1: full speed, self powered, config 1, UHCI root hub(0x0000), Intel(0x8086), rev 1.00 port 1 powered port 2 powered Controller /dev/usb5: addr 1: full speed, self powered, config 1, UHCI root hub(0x0000), Intel(0x8086), rev 1.00 port 1 powered port 2 powered 2010/1/19 Robert <[email protected]>: > Ted Unangst wrote: >> >> Plug it in. The kernel tells you. >> > > usbdevs -v also helps > > regards, > Robert > > -- Pau
