On Sat, Jun 5, 2010 at 5:27 PM, Edho P Arief <edhopr...@gmail.com> wrote:
> On Sun, Jun 6, 2010 at 5:14 AM, Neal Hogan <nealho...@gmail.com> wrote:
>> Hello,
>>
>> I just tried to upgrade my machine to 4.7 (release) and it IDs my hard
>> drives differently than 4.6 did. That is, when asked (during upgrade)
>> which disk the root partition is on it offers: sd0 wd0 wd1 wd2.
>> However, what I'm expecting is: wd0 wd1 wd2 wd3
>>
>> Thus, fsck fails and therefore the upgrade does too. Will upgrading
>> via source work? Fresh install? Note that I tried ramdisks from two
>> different mirrors and was attempting a net install. I found no
>> discussion/docs concerning this . . . I'm not even sure what to search
>> for.
>>
>
>> OpenBSD 4.6 (GENERIC.MP) #81: Thu Jul  9 21:26:19 MDT 2009
>> pciide0 at pci0 dev 17 function 0 "ATI SBx00 SATA" rev 0x00: DMA
>> (unsupported), channel 0 configured to native-PCI, channel 1
>> configured to native-PCI
>> pciide0: using apic 4 int 22 (irq 10) for native-PCI interrupt
>> pciide0: channel 0 ignored (not responding; disabled or no drives?)
>> wd0 at pciide0 channel 1 drive 0: <ST3750528AS>
>> wd0: 16-sector PIO, LBA48, 715404MB, 1465149168 sectors
>
>
>> OpenBSD 4.7 (GENERIC.MP) #130: Wed Mar 17 20:48:50 MDT 2010
>> ahci0 at pci0 dev 17 function 0 "ATI SBx00 SATA" rev 0x00: apic 4 int
>> 22 (irq 10), AHCI 1.1
>> scsibus0 at ahci0: 32 targets
>> sd0 at scsibus0 targ 1 lun 0: <ATA, ST3750528AS, CC38> SCSI3 0/direct
fixed
>> sd0: 715404MB, 512 bytes/sec, 1465149168 sec total
>
>
> In short: AHCI support for your SATA controller was added. Upgrade and
> modify fstab accordingly.
>
>

OK . . . but I have another SATA drive.

wd0 at pciide0 channel 0 drive 1: <ST3500418AS>
wd0: 16-sector PIO, LBA48, 476940MB, 976773168 sectors
wd0(pciide0:0:1): using PIO mode 4, DMA mode 2, Ultra-DMA mode 6

and it's not ID'ed that way.

Just to be clear, you mean for me to modify /etc/fstab, then upgrade .
. . right.

Thanks for the response, Edho.

> --
> O< ascii ribbon campaign - stop html mail - www.asciiribbon.org

Reply via email to