Considering you have some pretty big main bolts holding the head on I doubt
it. :)
Ratlow
From: "Marshall Grice IV" <[email protected]>
To: [email protected]
Subject: !.8l head on 2.0l block problems
Date: Sun, 10 Jun 2001 10:53:13 -0700
Dear Collective,
I am putting a 1.8l head on my 2.0l block and the head does not have a hole
for the drivers side alignment pin. Is this normal? I think my solution is
to take out the pin but i'm not sure if there is any reason why i shouldn't.
Is my head going to "pop" off if i don't have both pins in the block? I
wouldn't think so, but i'll feel better if someone else agrees with me.
Thanks,
Marshall
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
_____________
List Sponsor: http://www.netsville.com
To remove yourself from this list, send mail to [email protected] with
'unsubscribe a2_16v' in the body of your message
See us on the web at http://www.a2-16v.com
Visit the 16V Homepage at http://www.gti16v.org
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
_____________
List Sponsor: http://www.netsville.com
To remove yourself from this list, send mail to [email protected] with
'unsubscribe a2_16v' in the body of your message
See us on the web at http://www.a2-16v.com
Visit the 16V Homepage at http://www.gti16v.org
