I'm in the middle of installing a new 25mm autotech front swaybar. I'm having a couple of problems. First, I can't get the inboard bushings pressed compleyely into place. When I try to put the bushing clamps back on, they won't...quite...close.
The second problem is the one that worries me. I can't seem to get the links at the end of the bar into the holes at right angles. I can get them both into the holes in the control arms, but they're at about a 30 degree angle wrt vertical. If I tried to put the nuts and grometts back on, they'd be at a pretty severe angle... I tried flipping the bar upside down, but then I have about 1/16 inch between the bar and the tie rods...anyone have this problem? The old bar had ends that were parallel to the ground, but the autotech bar has ends that are sort of angled. What gives?? _____________ List Sponsor: http://www.netsville.com To remove yourself from this list, send mail to [email protected] with 'unsubscribe a2_16v' in the body of your message See us on the web at http://www.a2-16v.com Visit the 16V Homepage at http://www.gti16v.org
