On 04.05.2011 00:41, Henning Scholland wrote:
> Am 04.05.2011 00:08, schrieb Felix Hartmann:
>>
>>
>> On 04.05.2011 00:05, Henning Scholland wrote:
>>> Am 03.05.2011 23:37, schrieb Felix Hartmann:
>>>>
>>>> On 03.05.2011 23:27, Minko wrote:
>>>>> Yes, that is also a good alternative, 0x01 as a transparent line
>>>>> and on top either
>>>>> 0x10f01 or 0x10f02
>>>>>
>>>> you cannot make a line transparent by omitting it from the typfile,
>>>> but
>>>> go ahead and do your tries.
>>> Yes, but you can use a transparent png-file ;)
>>>
>>> Henning
>>>
>> And then you have streetnames shown, but no street.... If you remove
>> the streetnames on 0x01, you remove streetnames on the broken Oregon,
>> edge 800, gpsmaps 62 series, for all maps (until hard reset)
> The streetnames should be at 0x01, because this is rendered on top.
> 0x10f01 or 2 were rendered below and will be visible because of 0x01
> is transparent.
>
> Henning
>
What is rendered on top and what not depends on GPS Firmware. For old
GPS it is opposite to Mapsource 6.16 if you use a .TYPfile. If you omit
entries from typfile, it changes order. There are quite a lot of
variables, and in general stuff on top of each other is stupid. Better
use transparency wisely, it's much more powerful than layers or top/down
drawings, and it works consitstent on all GPS except Zumo (all that is
all that are able to use .TYP-files).
_______________________________________________
mkgmap-dev mailing list
[email protected]
http://www.mkgmap.org.uk/mailman/listinfo/mkgmap-dev
