Hi Nelson, the answer to your question reg. "How can I find out if it works?" is a bit more complicated. I test like this: Install the map in MapSource, start MapSource, press Ctrl+G two times to clear the "tile cache", create a route which should use the way if no restriction existed, verify that the route is NOT using the way with a restricted vehicle. Change routing to pedestrian (or whatever vehicle that should be alllowed to pass the barrier) and recalc the route. Now it should use the way. For both cases I also revert the route to check both directions. Whenever I find something unexpected I double-check (2x CTRL+G , check routing configuration ) and try again, before I am sure that it doesn't work.
Of course you can also use Basecamp for that. If you find that it works in the PC programs but not on a device, check if the software on the PC and on the device is up to date. Gerd > Date: Thu, 8 May 2014 17:28:53 -0300 > From: [email protected] > To: [email protected] > Subject: Re: [mkgmap-dev] Problem with barrier=gate and access=no > > Hi Gerd! > > On Thu, May 8, 2014 at 5:15 PM, GerdP <[email protected]> wrote: > > you have to add option --link-pois-to-ways to get what you want. > > Right. Good to know :-) > > Thank you very much! > > Best regards, > Nelson > _______________________________________________ > mkgmap-dev mailing list > [email protected] > http://www.mkgmap.org.uk/mailman/listinfo/mkgmap-dev
_______________________________________________ mkgmap-dev mailing list [email protected] http://www.mkgmap.org.uk/mailman/listinfo/mkgmap-dev
