Instructions to unsubscribe from this list at the end of the message - --------------------------------------------------------------------- alan
i suggest you ask melita to refresh your connection from their side. then reset your modem and power up your pc. joe - ----- Original Message ----- From: "Alan Gatt" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Friday, April 18, 2003 2:17 PM Subject: Re: [LINUX.ORG.MT] Cable Modem Trouble! > Instructions to unsubscribe from this list at the end of the message > --------------------------------------------------------------------- > I tried however no luck! > > My connection is set to LAN and these are the settings. > > The Network adapter settings: > Ip = nothing > netmask = 255.255.255.0 > boot protocol = dhcp > started on boot = yes > dhcp client = nothing > > The internet access settings > Gateway = 213.165.168.1 > > Any settings i missed out!? > > Tnx > ----- Original Message ----- > From: "Joseph" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Friday, April 18, 2003 3:24 PM > Subject: Re: [LINUX.ORG.MT] Cable Modem Trouble! > > > > Instructions to unsubscribe from this list at the end of the message > > --------------------------------------------------------------------- > > Hi Alan, > > > > I've had a cable modem connected to eth0 on my LM9.0 and 9.1 > > > > I always set it up when I installed the system. Mandrake found the eth0, I > > then told it to use DHCP, put in the DNS nos & system was working. > > > > I guess you now have to go to the Mandrake Control Center, Network & > Internet, > > & set up eth0 to use DHCP, save & reboot. Should have no problems now! > > > > Joseph > > > > > > > > On Friday 18 April 2003 12:49 pm, Alan Gatt wrote: > > > Hello list, > > > Please HELP! I realised that it was quite impossible to work the cable > > > modem uder USB in Mandrake 9.0 so i bougth a network card. But i still > > > cannot manage it! The network card is detected at eth0 and the network > > > configuration set to autodetect works fine and detects all! However when > i > > > try to connect it says connection failed! i am at loss. > > > > > > Any step by step help is greatly appreciated. Thanks! > > > > > > - Alan lost in Linux :) > > > > --------------------------------------------------------------------- > > You received this message because you are subscribed to the linux > > mailing list. If you do not wish to continue receiving this mailing > > list, please send a mail message to [EMAIL PROTECTED] > > containing only the text "unsubscribe linux" > > > > --------------------------------------------------------------------- > You received this message because you are subscribed to the linux > mailing list. If you do not wish to continue receiving this mailing > list, please send a mail message to [EMAIL PROTECTED] > containing only the text "unsubscribe linux" > - --------------------------------------------------------------------- You received this message because you are subscribed to the linux mailing list. If you do not wish to continue receiving this mailing list, please send a mail message to [EMAIL PROTECTED] containing only the text "unsubscribe linux" containing only the text "unsubscribe $LIST"
