Good to hear it! :P Enjoy ur 64bit pc!
Daniel -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Keith Vassallo Sent: 25 March 2005 11:50 To: Malta Linux User Group - general list Subject: Re: [LINUX.ORG.MT] Network card on 64bit Gentoo [SOLVED] Finally! I've managed to get this godforsaken livecd to do networking. All I had to do was add the 'noapic' option to the kernel. I loaded the sk98lin module (for my on-board Marvell 1G), configured it using net-setup and it works! Thanks for the help guys, Keith On Fri, 2005-03-25 at 11:19 +0100, Keith Vassallo wrote: > I really need to get my system working. Should I just forget Gentoo and > switch to something else? > > Keith > > On Thu, 2005-03-24 at 20:00 +0100, Keith Vassallo wrote: > > Also, the very same NIC worked on the very same PC under Knoppix > > > > Keith > > > > On Thu, 2005-03-24 at 19:15 +0100, Keith Vassallo wrote: > > > Are you sure about that? I find it hard to believe both my RealTek card > > > (which was working fine in another PC - just transferred it to this one) > > > and my NEW on-board Marvell card both aren't working... > > > > > > Keith > > > > > > On Thu, 2005-03-24 at 17:52 +0100, Gregory Smirnov wrote: > > > > Heh, it looks like your NIC is faulty. dmesg shows that NIC is connected to > > > > the network. You can play a bit with mii-diag (setting line between > > > > 10/100base with/without full duplex), but changing of the NIC will save your > > > > time. > > > > > > > > Gregory > > > > > > > > On Thursday 24 March 2005 15:20, Keith Vassallo wrote: > > > > > IP has not bound to the NIC... > > > > > > > > > > 1) What does that mean? > > > > > 2) How do I check it? > > > > > > > > > > Thanks, > > > > > > > > > > Keith > > > > > > > > > > On Thu, 2005-03-24 at 14:37 +0100, Iain Sims wrote: > > > > > > > ifconfig: > > > > > > > eth0 Link Encap:Ethernet HWaddr:00:0B:2B:0D:D3:D9 > > > > > > > inet addr:192.168.1.101 Bcast:192.168.1.255 MasK:255.255.255.0 > > > > > > > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > > > > > > > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > > > > > > > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > > > > > > > collisions:0 txqueuelen:1000 > > > > > > > RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) > > > > > > > Interrupt:19 Base address:0xc000 > > > > > > > > > > > > > > >From 192.168.1.101 icmp_seq=2 Destination Host Unreachable > > > > > > > > > > > > IP has not bound to the NIC it would seem. Can you check and confirm > > > > > > this is correct?? > > > > > > > > > > > > Iain. > > > > > > > > > > > > _______________________________________________ > > > > > > MLUG-list mailing list > > > > > > [email protected] > > > > > > http://mailserv.megabyte.net/mailman/listinfo/mlug-list > > > > > > > > > > _______________________________________________ > > > > > MLUG-list mailing list > > > > > [email protected] > > > > > http://mailserv.megabyte.net/mailman/listinfo/mlug-list > > > > _______________________________________________ > > > > MLUG-list mailing list > > > > [email protected] > > > > http://mailserv.megabyte.net/mailman/listinfo/mlug-list > > > > > > _______________________________________________ > > > MLUG-list mailing list > > > [email protected] > > > http://mailserv.megabyte.net/mailman/listinfo/mlug-list > > > > _______________________________________________ > > MLUG-list mailing list > > [email protected] > > http://mailserv.megabyte.net/mailman/listinfo/mlug-list > > _______________________________________________ > MLUG-list mailing list > [email protected] > http://mailserv.megabyte.net/mailman/listinfo/mlug-list _______________________________________________ MLUG-list mailing list [email protected] http://mailserv.megabyte.net/mailman/listinfo/mlug-list
