I don't have any specific data but had 2 Seagate drives in Raid failing within the warranty limit. Replace them with the refurbished ones and without any usage change they are still running perfectly after almost 4 years now..
I guess you have some good and bad (worst) drive. -- Philippe On Aug 21, 2014 5:12 PM, "H. Kurth Bemis" <[email protected]> wrote: > Hi everyone. > > After a reboot this morning one of our fileservers started acting up. I > am using zfs on linux (zol) and was alerted a device was marked as > unavailable. > > While the drive will be replaced ASAP, I was wondering if there was > anybody has seen anything like this before ans could offer up a > potential cause. The drive is about a year and a half old, while it had > a year warranty, this failure is premature in my book. > > Any commentary anybody has would be great. > > ~k > > ----- > [ 128.721850] eth0: no IPv6 routers present > [ 510.070368] mptsas: ioc0: attaching sata device: fw_channel 0, fw_id > 3, phy 3, sas_addr 0x1221000003000000 > [ 510.072657] scsi 6:0:4:0: Direct-Access ATA ST2000DM001-1CH1 > CC26 PQ: 0 ANSI: 5 > [ 510.074724] sd 6:0:4:0: Attached scsi generic sg5 type 0 > [ 510.075672] sd 6:0:4:0: [sde] 3907029168 512-byte logical blocks: > (2.00 TB/1.81 TiB) > [ 542.717383] mptscsih: ioc0: attempting task abort! > (sc=ffff8801a00803c0) > [ 542.717388] sd 6:0:4:0: CDB: Mode Sense(6): 1a 00 3f 00 04 00 > [ 547.074748] mptbase: ioc0: LogInfo(0x31140000): Originator={PL}, > Code={IO Executed}, SubCode(0x0000) cb_idx mptscsih_io_done > [ 547.075217] mptscsih: ioc0: task abort: SUCCESS (rv=2002) > (sc=ffff8801a00803c0) > [ 547.075229] mptscsih: ioc0: attempting target reset! > (sc=ffff8801a00803c0) > [ 547.075234] sd 6:0:4:0: CDB: Mode Sense(6): 1a 00 3f 00 04 00 > [ 547.075243] mptscsih: ioc0: target reset: FAILED > (sc=ffff8801a00803c0) > [ 547.075268] mptscsih: ioc0: attempting host reset! > (sc=ffff8801a00803c0) > [ 547.075274] mptbase: ioc0: Initiating recovery > [ 598.330777] mptscsih: ioc0: host reset: SUCCESS (sc=ffff8801a00803c0) > [ 598.339606] mptbase: ioc0: LogInfo(0x30030501): Originator={IOP}, > Code={Invalid Page}, SubCode(0x0501) cb_idx mptbase_reply > [ 598.339635] end_device-6:4: mptsas: ioc0: removing sata device: > fw_channel 0, fw_id 3, phy 3,sas_addr 0x1221000003000000 > [ 598.339641] phy-6:3: mptsas: ioc0: delete phy 3, phy-obj > (0xffff8801b54c8800) > [ 598.339649] port-6:4: mptsas: ioc0: delete port 4, sas_addr > (0x1221000003000000) > [ 608.329185] sd 6:0:4:0: Device offlined - not ready after error > recovery > [ 608.333284] sd 6:0:4:0: [sde] Write Protect is off > [ 608.333290] sd 6:0:4:0: [sde] Mode Sense: 00 b1 00 3c > [ 608.333387] sd 6:0:4:0: [sde] Asking for cache data failed > [ 608.333440] sd 6:0:4:0: [sde] Assuming drive cache: write through > [ 608.334168] sd 6:0:4:0: [sde] READ CAPACITY(16) failed > [ 608.334172] sd 6:0:4:0: [sde] Result: hostbyte=DID_NO_CONNECT > driverbyte=DRIVER_OK > [ 608.334177] sd 6:0:4:0: [sde] Sense not available. > [ 608.334432] sd 6:0:4:0: [sde] READ CAPACITY failed > [ 608.334435] sd 6:0:4:0: [sde] Result: hostbyte=DID_NO_CONNECT > driverbyte=DRIVER_OK > [ 608.334439] sd 6:0:4:0: [sde] Sense not available. > [ 608.334840] sd 6:0:4:0: [sde] Incomplete mode parameter data > [ 608.334891] sd 6:0:4:0: [sde] Assuming drive cache: write through > [ 608.334942] sde: detected capacity change from 2000398934016 to 0 > [ 608.335427] sd 6:0:4:0: [sde] READ CAPACITY(16) failed > [ 608.335431] sd 6:0:4:0: [sde] Result: hostbyte=DID_NO_CONNECT > driverbyte=DRIVER_OK > [ 608.335436] sd 6:0:4:0: [sde] Sense not available. > [ 608.335617] sd 6:0:4:0: [sde] READ CAPACITY failed > [ 608.335620] sd 6:0:4:0: [sde] Result: hostbyte=DID_NO_CONNECT > driverbyte=DRIVER_OK > [ 608.335624] sd 6:0:4:0: [sde] Sense not available. > [ 608.335745] sd 6:0:4:0: [sde] Write Protect is on > [ 608.335749] sd 6:0:4:0: [sde] Mode Sense: 40 03 a6 05 > [ 608.335857] sd 6:0:4:0: [sde] No Caching mode page found > [ 608.335908] sd 6:0:4:0: [sde] Assuming drive cache: write through > [ 608.335958] sd 6:0:4:0: [sde] Attached SCSI disk > [ 608.336317] scsi target6:0:4: mptsas: ioc0: delete device: fw_channel > 0, fw_id 3, phy 3, sas_addr 0x1221000003000000 > [ 1014.748077] mptsas: ioc0: attaching sata device: fw_channel 0, fw_id > 3, phy 3, sas_addr 0x1221000003000000 > [ 1035.469370] mptscsih: ioc0: attempting task abort! > (sc=ffff8801ab50eac0) > [ 1035.469375] scsi 6:0:5:0: CDB: Inquiry: 12 00 00 00 24 00 > [ 1039.722717] mptbase: ioc0: LogInfo(0x31130000): Originator={PL}, > Code={IO Not Yet Executed}, SubCode(0x0000) cb_idx mptscsih_io_done > [ 1039.723196] mptscsih: ioc0: task abort: SUCCESS (rv=2002) > (sc=ffff8801ab50eac0) > [ 1039.723209] mptscsih: ioc0: attempting target reset! > (sc=ffff8801ab50eac0) > [ 1039.723213] scsi 6:0:5:0: CDB: Inquiry: 12 00 00 00 24 00 > [ 1039.723222] mptscsih: ioc0: target reset: FAILED > (sc=ffff8801ab50eac0) > [ 1039.723247] mptscsih: ioc0: attempting host reset! > (sc=ffff8801ab50eac0) > [ 1039.723253] mptbase: ioc0: Initiating recovery > [ 1090.982807] mptscsih: ioc0: host reset: SUCCESS (sc=ffff8801ab50eac0) > [ 1100.981282] scsi 6:0:5:0: Device offlined - not ready after error > recovery > [ 1100.981417] scsi target6:0:5: mptsas: ioc0: delete device: fw_channel > 0, fw_id 3, phy 3, sas_addr 0x1221000003000000 > > > > _______________________________________________ > mlug mailing list > [email protected] > https://listes.koumbit.net/cgi-bin/mailman/listinfo/mlug-listserv.mlug.ca >
_______________________________________________ mlug mailing list [email protected] https://listes.koumbit.net/cgi-bin/mailman/listinfo/mlug-listserv.mlug.ca
