The patch titled
libata: PIIX3 support
has been removed from the -mm tree. Its filename was
libata-piix3-support.patch
This patch was dropped because it was merged into mainline or a subsystem tree
------------------------------------------------------
Subject: libata: PIIX3 support
From: Alan Cox <[EMAIL PROTECTED]>
This I believe completes the PIIX range of support for libata
This adds the table entries needed for the PIIX3, both a new PCI identifier
and a new mode list. It also fixes an erroneous access to PCI
configuration 0x48 on non UDMA capable chips.
Signed-off-by: Alan Cox <[EMAIL PROTECTED]>
Cc: Jeff Garzik <[EMAIL PROTECTED]>
Signed-off-by: Andrew Morton <[EMAIL PROTECTED]>
---
drivers/ata/ata_piix.c | 18 +++++++++++++++---
1 files changed, 15 insertions(+), 3 deletions(-)
diff -puN drivers/ata/ata_piix.c~libata-piix3-support drivers/ata/ata_piix.c
--- a/drivers/ata/ata_piix.c~libata-piix3-support
+++ a/drivers/ata/ata_piix.c
@@ -118,7 +118,7 @@ enum {
PIIX_80C_SEC = (1 << 7) | (1 << 6),
/* controller IDs */
- piix_pata_33 = 0, /* PIIX3 or 4 at 33Mhz */
+ piix_pata_33 = 0, /* PIIX4 at 33Mhz */
ich_pata_33 = 1, /* ICH up to UDMA 33 only */
ich_pata_66 = 2, /* ICH up to 66 Mhz */
ich_pata_100 = 3, /* ICH up to UDMA 100 */
@@ -128,6 +128,7 @@ enum {
ich6_sata_ahci = 7,
ich6m_sata_ahci = 8,
ich8_sata_ahci = 9,
+ piix_pata_mwdma = 10, /* PIIX3 MWDMA only */
/* constants for mapping table */
P0 = 0, /* port 0 */
@@ -165,6 +166,8 @@ static unsigned int in_module_init = 1;
static const struct pci_device_id piix_pci_tbl[] = {
#ifdef ATA_ENABLE_PATA
+ /* Intel PIIX3 for the 430HX etc */
+ { 0x8086, 0x7010, PCI_ANY_ID, PCI_ANY_ID, 0, 0, piix_pata_mwdma },
/* Intel PIIX4 for the 430TX/440BX/MX chipset: UDMA 33 */
/* Also PIIX4E (fn3 rev 2) and PIIX4M (fn3 rev 3) */
{ 0x8086, 0x7111, PCI_ANY_ID, PCI_ANY_ID, 0, 0, piix_pata_33 },
@@ -441,7 +444,7 @@ static const struct piix_map_db *piix_ma
};
static struct ata_port_info piix_port_info[] = {
- /* piix_pata_33: 0: PIIX3 or 4 at 33MHz */
+ /* piix_pata_33: 0: PIIX4 at 33MHz */
{
.sht = &piix_sht,
.flags = PIIX_PATA_FLAGS,
@@ -543,6 +546,14 @@ static struct ata_port_info piix_port_in
.port_ops = &piix_sata_ops,
},
+ /* piix_pata_mwdma: 10: PIIX3 MWDMA only */
+ {
+ .sht = &piix_sht,
+ .flags = PIIX_PATA_FLAGS,
+ .pio_mask = 0x1f, /* pio0-4 */
+ .mwdma_mask = 0x06, /* mwdma1-2 ?? CHECK 0 should be ok but
slow */
+ .port_ops = &piix_pata_ops,
+ },
};
static struct pci_bits piix_enable_bits[] = {
@@ -787,7 +798,8 @@ static void do_pata_set_dmamode (struct
{ 2, 3 }, };
pci_read_config_word(dev, master_port, &master_data);
- pci_read_config_byte(dev, 0x48, &udma_enable);
+ if (ap->udma_mask)
+ pci_read_config_byte(dev, 0x48, &udma_enable);
if (speed >= XFER_UDMA_0) {
unsigned int udma = adev->dma_mode - XFER_UDMA_0;
_
Patches currently in -mm which might be from [EMAIL PROTECTED] are
ia64-add-pci_get_legacy_ide_irq.patch
git-libata-all.patch
add-suport-for-marvell-88se6121-in-pata_marvell.patch
git-mtd.patch
z85230-spinlock-logic.patch
resend-iphase-64bit-cleanup.patch
make-sure-uart-is-powered-up-when-dumping-mctrl-status.patch
perle-multimodem-card-pci-ras-detection.patch
pnx8550-uart-driver.patch
pnx8550-uart-driver-fixes.patch
drivers-scsi-ncr5380c-replacing-yield-with-a.patch
drivers-scsi-mca_53c9xc-save_flags-cli-removal.patch
x86_64-do-not-enable-the-nmi-watchdog-by-default.patch
char-tty-delete-wake_up_interruptible-after-tty_wakeup.patch
char-tty_wakeup-cleanup.patch
proc-remove-useless-and-buggy-nlink-settings.patch
tty-improve-encode_baud_rate-logic.patch
tty-make-__proc_set_tty-static.patch
tty-clarify-disassociate_ctty.patch
tty-fix-the-locking-for-signal-session-in-disassociate_ctty.patch
signal-use-kill_pgrp-not-kill_pg-in-the-sunos-compatibility-code.patch
signal-rewrite-kill_something_info-so-it-uses-newer-helpers.patch
pid-make-session_of_pgrp-use-struct-pid-instead-of-pid_t.patch
pid-use-struct-pid-for-talking-about-process-groups-in-exitc.patch
pid-replace-is_orphaned_pgrp-with-is_current_pgrp_orphaned.patch
tty-update-the-tty-layer-to-work-with-struct-pid.patch
pid-replace-do-while_each_task_pid-with-do-while_each_pid_task.patch
pid-remove-now-unused-do_each_task_pid-and-while_each_task_pid.patch
pid-remove-the-now-unused-kill_pg-kill_pg_info-and-__kill_pg_info.patch
edac-e752x-bit-mask-fix.patch
edac-e752x-byte-access-fix.patch
edac-new-opteron-athlon64-memory-controller-driver.patch
edac-k8-driver-coding-tidy.patch
hpt3xx-rework-rate-filtering.patch
hpt3xx-rework-rate-filtering-tidy.patch
hpt3xx-print-the-real-chip-name-at-startup.patch
hpt3xx-switch-to-using-pci_get_slot.patch
hpt3xx-cache-channels-mcr-address.patch
hpt3x7-merge-speedproc-handlers.patch
hpt370-clean-up-dma-timeout-handling.patch
hpt3xx-init-code-rewrite.patch
piix-fix-82371mx-enablebits.patch
pdc202xx_new-remove-useless-code.patch
pdc202xx_-remove-check_in_drive_lists-abomination.patch
piix-tuneproc-fixes-cleanups.patch
slc90e66-carry-over-fixes-from-piix-driver.patch
hpt36x-pci-clock-detection-fix.patch
atiixpc-remove-unused-code.patch
atiixpc-sb600-ide-only-has-one-channel.patch
atiixpc-add-cable-detection-support-for-ati-ide.patch
jmicron-warning-fix.patch
-
To unsubscribe from this list: send the line "unsubscribe mm-commits" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
