The patch titled
s2ram: kill old debugging junk
has been removed from the -mm tree. Its filename was
s2ram-kill-old-debugging-junk.patch
This patch was dropped because it was merged into mainline or a subsystem tree
------------------------------------------------------
Subject: s2ram: kill old debugging junk
From: Pavel Machek <[EMAIL PROTECTED]>
This removes old debugging stuff, that should be no longer neccessary. It
accessed VGA hardware (which may not be ready at this point), and used LEDs
at port 80 for debugging.
Signed-off-by: Pavel Machek <[EMAIL PROTECTED]>
Acked-by: Rafael J. Wysocki <[EMAIL PROTECTED]>
Cc: Andi Kleen <[EMAIL PROTECTED]>
Signed-off-by: Andrew Morton <[EMAIL PROTECTED]>
---
arch/x86/kernel/acpi/wakeup_32.S | 12 ----------
arch/x86/kernel/acpi/wakeup_64.S | 32 -----------------------------
2 files changed, 1 insertion(+), 43 deletions(-)
diff -puN arch/x86/kernel/acpi/wakeup_32.S~s2ram-kill-old-debugging-junk
arch/x86/kernel/acpi/wakeup_32.S
--- a/arch/x86/kernel/acpi/wakeup_32.S~s2ram-kill-old-debugging-junk
+++ a/arch/x86/kernel/acpi/wakeup_32.S
@@ -11,7 +11,7 @@
#
# If physical address of wakeup_code is 0x12345, BIOS should call us with
# cs = 0x1234, eip = 0x05
-#
+#
#define BEEP \
inb $97, %al; \
@@ -52,7 +52,6 @@ wakeup_code:
BEEP
1:
mov $(wakeup_stack - wakeup_code), %sp # Private stack
is needed for ASUS board
- movw $0x0e00 + 'S', %fs:(0x12)
pushl $0 # Kill any
dangerous flags
popfl
@@ -90,9 +89,6 @@ wakeup_code:
# make sure %cr4 is set correctly (features, etc)
movl real_save_cr4 - wakeup_code, %eax
movl %eax, %cr4
- movw $0xb800, %ax
- movw %ax,%fs
- movw $0x0e00 + 'i', %fs:(0x12)
# need a gdt -- use lgdtl to force 32-bit operands, in case
# the GDT is located past 16 megabytes.
@@ -102,8 +98,6 @@ wakeup_code:
movl %eax, %cr0
jmp 1f
1:
- movw $0x0e00 + 'n', %fs:(0x14)
-
movl real_magic - wakeup_code, %eax
cmpl $0x12345678, %eax
jne bogus_real_magic
@@ -122,13 +116,11 @@ real_save_cr4: .long 0
real_magic: .long 0
video_mode: .long 0
realmode_flags: .long 0
-beep_flags: .long 0
real_efer_save_restore: .long 0
real_save_efer_edx: .long 0
real_save_efer_eax: .long 0
bogus_real_magic:
- movw $0x0e00 + 'B', %fs:(0x12)
jmp bogus_real_magic
/* This code uses an extended set of video mode numbers. These include:
@@ -194,7 +186,6 @@ wakeup_pmode_return:
movw %ax, %es
movw %ax, %fs
movw %ax, %gs
- movw $0x0e00 + 'u', 0xb8016
# reload the gdt, as we need the full 32 bit address
lgdt saved_gdt
@@ -218,7 +209,6 @@ wakeup_pmode_return:
jmp *%eax
bogus_magic:
- movw $0x0e00 + 'B', 0xb8018
jmp bogus_magic
diff -puN arch/x86/kernel/acpi/wakeup_64.S~s2ram-kill-old-debugging-junk
arch/x86/kernel/acpi/wakeup_64.S
--- a/arch/x86/kernel/acpi/wakeup_64.S~s2ram-kill-old-debugging-junk
+++ a/arch/x86/kernel/acpi/wakeup_64.S
@@ -41,7 +41,6 @@ wakeup_code:
# Running in *copy* of this code, somewhere in low 1MB.
- movb $0xa1, %al ; outb %al, $0x80
cli
cld
# setup data segment
@@ -65,11 +64,6 @@ wakeup_code:
cmpl $0x12345678, %eax
jne bogus_real_magic
- call verify_cpu # Verify the cpu supports long
- # mode
- testl %eax, %eax
- jnz no_longmode
-
testl $1, realmode_flags - wakeup_code
jz 1f
lcall $0xc000,$3
@@ -84,12 +78,6 @@ wakeup_code:
call mode_set
1:
- movw $0xb800, %ax
- movw %ax,%fs
- movw $0x0e00 + 'L', %fs:(0x10)
-
- movb $0xa2, %al ; outb %al, $0x80
-
mov %ds, %ax # Find 32bit wakeup_code addr
movzx %ax, %esi # (Convert %ds:gdt to a liner
ptr)
shll $4, %esi
@@ -117,14 +105,10 @@ wakeup_32_vector:
.code32
wakeup_32:
# Running in this code, but at low address; paging is not yet turned on.
- movb $0xa5, %al ; outb %al, $0x80
movl $__KERNEL_DS, %eax
movl %eax, %ds
- movw $0x0e00 + 'i', %ds:(0xb8012)
- movb $0xa8, %al ; outb %al, $0x80;
-
/*
* Prepare for entering 64bits mode
*/
@@ -200,16 +184,11 @@ wakeup_long64:
*/
lgdt cpu_gdt_descr
- movw $0x0e00 + 'n', %ds:(0xb8014)
- movb $0xa9, %al ; outb %al, $0x80
-
movq saved_magic, %rax
movq $0x123456789abcdef0, %rdx
cmpq %rdx, %rax
jne bogus_64_magic
- movw $0x0e00 + 'u', %ds:(0xb8016)
-
nop
nop
movw $__KERNEL_DS, %ax
@@ -220,13 +199,11 @@ wakeup_long64:
movw %ax, %gs
movq saved_rsp, %rsp
- movw $0x0e00 + 'x', %ds:(0xb8018)
movq saved_rbx, %rbx
movq saved_rdi, %rdi
movq saved_rsi, %rsi
movq saved_rbp, %rbp
- movw $0x0e00 + '!', %ds:(0xb801a)
movq saved_rip, %rax
jmp *%rax
@@ -256,21 +233,12 @@ realmode_flags: .quad 0
.code16
bogus_real_magic:
- movb $0xba,%al ; outb %al,$0x80
jmp bogus_real_magic
.code64
bogus_64_magic:
- movb $0xb3,%al ; outb %al,$0x80
jmp bogus_64_magic
-.code16
-no_longmode:
- movb $0xbc,%al ; outb %al,$0x80
- jmp no_longmode
-
-#include "../verify_cpu_64.S"
-
/* This code uses an extended set of video mode numbers. These include:
* Aliases for standard modes
* NORMAL_VGA (-1)
_
Patches currently in -mm which might be from [EMAIL PROTECTED] are
origin.patch
git-acpi.patch
working-3d-dri-intel-agpko-resume-for-i815-chip.patch
-
To unsubscribe from this list: send the line "unsubscribe mm-commits" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
