I created a startup script that just creates the /var/run/mongrel_cluster on boot, since it's removed every time you restart.
On 5/8/07, Ehud Rosenberg <[EMAIL PROTECTED]> wrote: > Hi everyone, > I am going crazy over here! :) > I just want to be able to use --clean with my mongrel_rails > cluster::start command. > I've upgraded to mongrel_cluster 1.0.1.1 and mongrel_rails 1.0.1. > my config file is in /etc/mongrel_rails/config.yml > and contains: > --- > log_file: log/mongrel.log > port: 8000 > pid_file: /var/run/mongrel_cluster/mongrel.pid > servers: 2 > address: 127.0.0.1 > environment: production > > in the following post it says the init.rb script from mongrel_cluster > should create the var/run directory itself, but it does not seem to do > so ( I get the message: > !!! Path to log file not valid: log/mongrel.8001.log > mongrel::start reported an error. Use mongrel_rails mongrel::start -h > to get help) > > Also, when I manually set the pid file dir to what it used to be (the > log dir of my app) > it does not clean it up and still give the old message that a PID > already exists - i'm not sure if that's because it's not in /var/run > as I have seen different comments on this. > > Any help would be appreciated... > > Thanks! > Ehud. > > PS - I have also tried running mongrel_rails cluster::configure -C / > etc/mongrel_rails/config.yml again but all it did was overwrite my > file... > > > _______________________________________________ > Mongrel-users mailing list > Mongrel-users@rubyforge.org > http://rubyforge.org/mailman/listinfo/mongrel-users > _______________________________________________ Mongrel-users mailing list Mongrel-users@rubyforge.org http://rubyforge.org/mailman/listinfo/mongrel-users