Please compile an ARMv7 for pi2's, which is also better for most newer
arm devices. (excludes the latest ARMv8 / AARch64 devices.)
ARMv6 needs to be complied with Hard Float support to benefit the rpi1
hardware.
__________________________________. https://eXtremeSHOK.com
.__________________________________
On 10-Oct-15 12:56 PM, Martin Pala wrote:
It is compile on Raspberry Pi 1 (ARMv6), should run on newer ARM
architectures too (we test the same binary runs on Raspberry Pi 2 too)
On 10 Oct 2015, at 12:52, [email protected]
<mailto:[email protected]> wrote:
This is compiled for which arm exactly ?
Sent from my iPhone
On 10 Oct 2015, at 12:32 PM, Martin Pala <[email protected]
<mailto:[email protected]>> wrote:
Please can you test the pre-compiled binary:
https://mmonit.com/monit/dist/binary/5.14/monit-5.14-linux-arm.tar.gz
Regards,
Martin
On 09 Oct 2015, at 17:50, Terry Duncan <[email protected]
<mailto:[email protected]>> wrote:
I have cross-compiled monit 5.13 for ARM and have it running on my
ARM system. When it hits an exception, I get a SEGV in the longjmp
call. Has anyone seen this problem and have a solution or suggestion?
Thanks
--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general
--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general
--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general
--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general
--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general
