Hello,
>
> 1) Using Solaris' tar will lead to failed builds due to a rules problem
> in jay. A work around was eventually found in an old mailing list
> reference to this problem. The work around suggested using cpio, pax,
> or GNU's tar to "untar" the file. It would have been helpful to have a
> mention of this on the web site or in the README file.
>
>
> 2) Do not use any of Sun's tools for the build. configure may find
> some of Sun's tools when run. However, I had compilation problems when
> they were used. Instead, using gmake for make, and CC=gcc within the
> CFLAGS will provide a better chance of a successful build.
>
>
> 3) The generated Makefile had an incorrect INSTALL variable. "gmake
> install" was failing because the INSTALL was set to ./install-sh. The
> script goes into numerous sub directories where install-sh does not
> exist. I had to edit Makefile to set the correct path to install-sh.
>
> Note, I'm not sure if there was a problem during the run of configure or
> something in my setup, but this was something I wanted to report just in
> case.
>
>
> 4) This problem is not related to build/installation, but I thought
> someone may want to take a look at it, as it *does not* occur when Vault
> is run on Linux (installed by use of binaries). When the Vault command
> line client is called, the following error occurs:
Thanks for these notes, I have included some of these in the README and
also in:
http://www.mono-project.com/Mono:SPARC
Miguel
_______________________________________________
Mono-list maillist - [email protected]
http://lists.ximian.com/mailman/listinfo/mono-list
