You don't need make install --enable-gmpcompat any more. Hasn't been in MPIR for ages.
Just do make install. You still have to pass --enable-gmpcompat to configure of course. Bill. On 1 June 2010 22:30, William Stein <[email protected]> wrote: > On Tue, Jun 1, 2010 at 2:14 PM, Minh Nguyen <[email protected]> wrote: >> Hi folks, >> >> MPIR 2.1.0-rc2 was released on 01st June 2010. >> >> Source: >> http://www.mpir.org/mpir-2.1.0-rc2.tar.gz >> >> Documentation: >> http://www.mpir.org/mpir-2.1.0.pdf >> >> A number of issues reported with the 2.1.0-rc1 release [1] are fixed. >> Please test and report all issues. >> >> If you are having failures when building or tuning, try setting the >> following prior to configuring and build: >> >> $ export MAKE='make' >> >> If you have failures when running the test suite, try edit the file >> mpirtest to use only one CPU. You can use/tweak this script [2] to >> automate these steps: configure, build, check, tune, run test suite. >> >> [1] >> http://groups.google.com/group/mpir-devel/browse_thread/thread/4550cb9a8aae0719/ >> >> [2] http://sage.math.washington.edu/home/mvngu/apps/mpir/go-build.sh > > I made an spkg from this for Sage, and it doesn't work, since the > install-gmpcompat target is suddenly gone. What am I supposed to use > instead to install gmpcompat'ability? > > make[4]: Leaving directory > `/mnt/usb1/scratch/wstein/build/sage-4.4.2.rc0/spkg/build/mpir-2.1.0-rc2/src' > make[3]: Leaving directory > `/mnt/usb1/scratch/wstein/build/sage-4.4.2.rc0/spkg/build/mpir-2.1.0-rc2/src' > make[2]: Leaving directory > `/mnt/usb1/scratch/wstein/build/sage-4.4.2.rc0/spkg/build/mpir-2.1.0-rc2/src' > make[1]: Leaving directory > `/mnt/usb1/scratch/wstein/build/sage-4.4.2.rc0/spkg/build/mpir-2.1.0-rc2/src' > make: *** No rule to make target `install-gmpcompat'. Stop. > Error installing MPIR. > > real 2m6.588s > user 1m11.950s > sys 0m51.550s > > > -- > William Stein > Professor of Mathematics > University of Washington > http://wstein.org > > -- > You received this message because you are subscribed to the Google Groups > "mpir-devel" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]. > For more options, visit this group at > http://groups.google.com/group/mpir-devel?hl=en. > > -- You received this message because you are subscribed to the Google Groups "mpir-devel" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/mpir-devel?hl=en.
